Loading ...
Loading ...
Loading ...
21
HT-X1
Preparation for Use
" Speaker connection
To prevent accidental short-circuits between and termi-
nals, connect the speaker wires to the speakers first and then
to the subwoofer/amplifier unit.
When connecting speakers, match the colors of the back label
on the speaker, to the tube for the speaker wire, and speaker
terminal of the subwoofer/amplifier unit.
Caution:
! The supplied speakers are exclusively for the HT-X1. Do not
connect them to other equipment, and do not connect other
speakers to the HT-X1. It may cause malfunction.
!
Do not mistake the and , and right and left terminals of the
speaker wires. (The right speaker is placed on the right when you
face the subwoofer/amplifier unit.)
!
Do not stand or sit on the speakers. You may be injured.
!
Do not allow any objects to fall into or to be placed in the bass
reflex ducts of the subwoofer/amplifier unit.
" Attaching the optional floor speaker stand
The front speakers and surround speakers support the optional floor
speaker stand (see page 65). Remove the original stand for each
speaker using a screwdriver first. For details, refer to the manual for
the floor speaker stand.
Note:
Keep the removed speaker stands or screw in a safe place.
Make sure to leave the AC power cord disconnected when
connecting the speakers.
Subwoofer/
amplifier unit
Example: To connect the left front speaker.
1 Connect the wires to the speakers.
Red
Red
Black
Black
2 Connect the other end to the
subwoofer/amplifier unit.
Tube (white)
Tube (white)
Speaker
terminal
(white)
Label (white)
!
The speaker grilles are not removable.
!
Do not short-circuit the speaker wire. If it
happens with the power on, the protection
circuit is activated and the system enters the
stand-by mode. In this case, check that the
speaker wire is connected correctly before
turning on the power again.
Incorrect
Loading ...
Loading ...
Loading ...