Loading ...
Loading ...
Loading ...
4
CHOOSING THE RIGHT
DETERGENT
Use only High Efficiency detergents. The package will be marked
“HE” or “High Efficiency.” Low-water washing creates excessive
sudsing with a non-HE detergent. Using non-HE detergent will
likely result in longer cycle times and reduced rinsing
performance. It may also result in component failure and, over
time, buildup of mold or mildew. HE detergents should be low-
sudsing and quick-dispersing to produce the right amount of suds
for the best performance. They should hold soil in suspension so it
is not redeposited onto clean clothes. Not all detergents labeled
as High Efficiency are identical in formulation and their ability to
reduce suds. For example, natural, organic, or homemade HE
detergents may generate a high level of suds. If you use one of
these and see an “Sd” or “Sud” error code appear in the display,
consider using a different HE detergent. Always follow the
detergent manufacturer’s instructions to determine the amount of
detergent to use. Do not go over the Max line on the dispenser.
Adding Laundry Products
Adding HE detergent to basket:
Single-dose laundry packets, Oxi-
type boosters, color-safe bleach, or
scented crystals can be added to
the drum prior to adding laundry.
When using single-dose laundry
packets, make sure that the bulk
dispenser is disabled (on some
models) or off.
NOTE: Follow the manufacturer’s instructions to determine the
amount of laundry products to use.
Adding liquid chlorine bleach to single-load dispenser:
Add liquid chlorine bleach to
the bleach compartment. Do
not overfill, dilute, or use more
than 2⁄3 cup (165 mL). Do not
use color-safe bleach or Oxi in
the same cycle with liquid
chlorine bleach.
IMPORTANT:
n Always measure liquid chlorine bleach. Use a measuring cup
with a pour spout; do not guess.
n Do not fill beyond the “MAX” line. Overfilling could cause
garment damage.
n Do not use thickened, easy-pour, or no-splash bleach when
running the Clean Washer with affresh
®
cycle, as excess suds
may occur.
n On some models: Do not add liquid chlorine bleach to the bulk
dispenser.
n Slowly close dispenser drawers. Make sure the drawers are
closed completely (on some models).
Adding liquid fabric softener to single-load dispenser:
Pour a measured amount of liquid
fabric softener into liquid fabric
softener compartment. Always
follow manufacturer’s directions for
correct amount of fabric softener,
based on your load size. Disable
the 1-Liter Load & Go
™ dispenser if
not used to dispense detergent (on
some models).
Fabric softener is always dispensed in the last rinse, even if
Extra Rinse is selected.
IMPORTANT: Do not overfill, dilute, or use more than the
manufacturer-recommended quantity of fabric softener. Do not fill
past the “MAX” line. Overfilling dispenser will cause fabric softener
to immediately dispense into washer.
n Do not spill or drip any fabric softener onto the clothes.
n Do not use liquid fabric softener dispenser balls in this washer.
They will not dispense correctly.
n Do not use fabric softener sheets, as they can stain the load.
Adding HE detergent to Optimal Dispense Drawer (on some
models):
This compartment holds up to
14.3 oz. (424 ml) of liquid HE
detergent allowing you to avoid
having to refill detergent for
each load. Also, this will use
just the right amount of
detergent required for a
particular load/cycle.
NOTE: Do not add single-dose laundry packets, Oxi-type
boosters, color-safe bleach, or fabric softener crystals to
dispensers. They will not dispense correctly.
Adding HE detergent to Load & Go
™ dispenser (on some
models):
Use only High Efficiency (HE) liquid detergents. The bulk
dispensers will hold about 67.6 oz. (2 L) or 33.8 oz. (1 L) of liquid
HE detergent, depending on dispenser, or enough for many loads
of laundry.
To fill bulk dispensers (on some models):
Open the dispenser drawer by pulling on the handle at the base of
the washer. If desired, the drawer can be completely removed
from the washer.
Locate the Load & Go
™ bulk dispenser. Gently
pull up on the tab located on the bulk dispenser
lid to lift the fill door.
Fill to the “MAX” line (see illustrations at right)
with HE liquid detergent or liquid fabric softener
(1-liter dispenser only). Close fill door. It will click
into place. Make sure the concentration setting
is correct (see the online “Cycle Guide”).
It is recommended that you rinse out the Load &
Go
™ containers when refilling, when changing
detergent types or concentrations, or when the
washer will not be used for an extended period.
For instructions on cleaning the dispenser
cartridge, see “Washer Care” in the “Washer
Maintenance and Care” section of your Owner’s
Manual.
Adding HE detergent to single-load dispenser:
Pour a measured amount of HE
detergent into detergent
compartment. For powdered
detergent, lift the selector to the high
position. For liquid detergent, push
down the selector to the low position.
Do not overfill; adding too much detergent may cause detergent
to be dispensed into the washer too early.
Loading ...
Loading ...
Loading ...