Loading ...
Loading ...
Loading ...
ERROR MESSAGES
A-36
This stitch is not “Dual Feed Mode” compatible. This message appears when the optional dual feed foot
cannot be used with the current stitch. Select other stitch. (see
page B-67)
This USB media cannot be used. This message is displayed when you try to use incompatible
media.
This USB media is incompatible. This message is displayed when you try to use incompatible
USB media. For a list of compatible USB media, visit
“ http://solutions.brother.com
”.
To thread the needle, please remove the fabric from under the
presser foot.
This message is displayed if you press the “Automatic
Threading” button while the dual feed foot is attached and the
presser foot height is 3 mm (1/8 inches) or higher.
Remove the fabric, and then press the “Automatic Threading”
button again.
Transmitting by USB This message is displayed while the USB media is
transmitting.
Turn off the power and replace the needle plate. This message is displayed when you try to sew with a stitch
other than a middle needle position stitch while the single-hole
needle plate is installed.
This message is displayed when the needle plate is removed
with the machine on or when the machine is turned on and
“Embroidery” or “Embroidery Edit” mode is selected (see page
B-22).
USB media error This message is displayed when an error occurs with the USB
media.
USB media is not loaded. Load USB media. This message is displayed when you try to recall or save a
pattern while no USB media is loaded.
Use the presser foot lifter button to lower the presser foot. This message is displayed when a button, such as the
“Start/Stop” button, is pushed while the presser foot is raised.
When the speed controller is set to control the zigzag stitch
width, the "Start/Stop" button does not operate.
This message is displayed when the speed control lever is set
to control the zigzag stitch width, and the “Start/Stop” button
is pushed. Use the foot controller to operate the machine.
Marks Error Messages Cause/Solution
Loading ...
Loading ...
Loading ...