Loading ...
Loading ...
Loading ...
IN CASE OF EMERGENCY 305
Front Fog Lamp — Halogen
1. Remove fasteners from inner wheel liner
and carefully peel back liner for access.
2. Reach through the front fascia to the fog
lamp housing to access the bulb.
3. Rotate the front fog lamp bulb counterclock-
wise, and remove the bulb from the front fog
lamp housing.
Front Fog Lamp Socket
4. Disconnect the bulb from the electrical
connector and then connect the replace-
ment bulb.
5. Install the front fog lamp bulb into the front
fog lamp housing, and rotate the bulb clock-
wise to lock it in place.
6. Position the inner wheel liner in place and
install fasteners.
Rear Liftgate Mounted Back-Up Lamps And
Tail Lamps (If Bulb Equipped)
1. Raise the liftgate.
2. Use a fiber stick or flat blade screw driver to
pry off the bulb access cover on the lower
liftgate trim.
3. Back-up lamps/tail lamp (if bulb equipped)
are now visible. Rotate socket(s) counter-
clockwise.
4. Remove/replace bulb(s).
5. Reinstall the socket(s).
6. Reverse process to reinstall the liftgate
trim.
Rear Bodyside Mounted Taillamps
1. Raise the liftgate.
2. Remove two torx head screws on the
bodyside lamp using a T30 screwdriver.
3. Remove lamp from vehicle body and locate
bulb socket on rear of lamp. Rotate socket
counterclockwise.
4. Remove/replace bulb(s).
5. Reinstall the socket(s).
6. Reverse process to reinstall the lamp onto
vehicle.
Center High Mounted Stop Lamp (CHMSL)
The center high-mounted stop lamp is an LED
assembly. See an authorized dealer for replace-
ment.
Rear License Lamp
The rear license lamps are LED. See an autho-
rized dealer for replacement.
CAUTION!
Do not touch the new bulb with your fingers.
Oil contamination will severely shorten bulb
life. If the bulb comes in contact with any oily
surface, clean the bulb with rubbing alcohol.
6
20_RU_OM_EN_USC_t.book Page 305
Loading ...
Loading ...
Loading ...