Loading ...
Loading ...
Loading ...
10
REFRIGERATOR INSTALLATION
HOW TO REMOVE AND INSTALL REFRIGERATOR DOOR
1. Removing Refrigerator Doors
Remove the left-side door first.
NOTE: Handle, top hinge and hinge cover appearance may vary from illustrations on this page.
WARNING
ţ Disconnect electrical supply to the refrigerator before installing. Failure to do so could result in death or serious
injury.
ţ Do not put hands or feet or metal sticks into the air vents, base grille, or bottom of the refrigerator. You may be
injured or receive an electrical shock.
ţ Be careful when you work with the hinge, base grille, and stopper. You may be injured.
; Left Door
ţ Pull the water tube out of the fitting while pressing the release ring on the fitting (1).
NOTE: When you pull out the tube, first you have to push the collet by opposite direction of arrow in the upper
picture and pull the tube out by direction of arrow.
ţ Open the door. Remove the top hinge cover screw (2 ).
ţ Use a flat blade screwdriver to lift the tabs on the front underside of the cover (3). Lift up the cover.
ţ Remove the cover. Pull out the tube (4).
ţ Disconnect all wire harness (5).
ţ Remove the grounding screw(6).
ţ Rotate hinge lever (7) counterclockwise. Lift the top hinge (8) free of the hinge lever latch (9).
ţ Place the door on a non-scratching surface with the inside up.
; Right Door
ţ Open the door. Remove the top hinge cover sc
rew (10).
ţ Use a flat blade screwdriver to lift the tabs on the front underside of the cover (11). Lift up the cover.
ţ Rotate hinge lever (12) clockwise. Lift the top hinge (13) free of the hinge lever latch (14).
ţ Place the door on a non-scratching surface with the inside up.
CAUTION: When lifting the hinge free of the latch, be careful that the door does not fall forward.
ţ Lift the door from the middle hinge pin and remove the door.
ţ Place the door, inside facing up, on a nonscratching surface.
Collet
(1)
REFRIGERATOR INSTALLATION
(2)
(3)
(5)
(4)
(7)
(8)
(9)
(6)
(10)
(11)
(12)
(13)
(14)
Loading ...
Loading ...
Loading ...