Loading ...
Loading ...
Loading ...
12
Headline
Cleaning & Maintenance
WARNING
A steam cleaner is not to be used for cleaning appliance.
Cleaning Problems on Glass Ceramic Top (cont.)
Problem Cause To Prevent To Remove
Metal markings (silver/
gray marks)
Sliding or scraping metal
cookware
on glass top.
DO NOT slide
metal objects across top.
Remove metal marks before the glass top
is used again. Apply cleaning cream with
a damp
paper towel and scrub with a nylon scrub
pad or brush. Rinse thoroughly and
dry.
Metal markings (silver/
gray marks)
Condensation
from cooking may cause
minerals found in water and
acids to drip on to glass top
and cause gray deposits (the
spots are often so thin they
appear
to be in the glass top).
Make sure the bottom of
cookware is dry before
cooking. Daily use of
cleaning cream will help
keep top free from hard
water mineral deposits and
food discoloration.
Mix cleaning
cream with water and apply a thick paste
to stained area. Scrub vigorously. If stain
is not removed, reapply cleaner and
repeat process. Also
try cleaning procedure for smearing and
streaking.
Pitting or aking Boil over of sugar syrup on
glass top. This can cause
pitting if not removed
immediately.
Watch sugar and syrups
carefully to avoid boil
overs.
Turn element to O ; use several paper
towels to wipe the spill immediately.
Let glass top cool and carefully scrape
o remainder of burn-o with a single-
edged razor blade held at a 30° angle.
Cooktop Surfaces
Several di erent nishes have been used in your cooktop. Cleaning instructions for each surface are given below. NEVER USE
AMMONIA, STEEL WOOL PADS OR ANY ABRASIVE CLOTHS AND MATERIALS SUCH AS CLEANSERS, OVEN CLEANERS, OR ABRASIVE
POWDERS. THEY CAN PERMANENTLY DAMAGE YOUR COOKTOP.
Control Panel
DO NOT use any cleaners containing ammonia, abrasives or stainless steel cleaners on any surface that contains graphics. These
products could remove the graphics from the control panel. Apply hot, soapy water to a soft clean cloth. DO NOT spray liquids directly
onto the control panel.
Control Knobs
MAKE SURE ALL CONTROL KNOBS POINT TO THE “OFF” POSITION BEFORE REMOVING. Pull the knobs straight o . Wash in detergent and
warm water. Dry completely and replace by pushing rmly onto stem.
Stainless Steel Parts
All stainless steel body parts should be wiped regularly with hot, soapy water at the end of each cooling period and with a liquid
cleaner designed for that material when soapy water will not do the job. DO NOT use steel wool, abrasive cloths, cleansers, or powders.
If necessary, scrape stainless steel to remove encrusted materials, soak the area with hot towels to loosen the material, then use a
wooden or nylon spatula or scraper. DO NOT use a metal knife, spatula, or any other metal tool to scrape stainless steel. DO NOT permit
citrus or tomato juice to remain on stainless steel surface, as citric acid will permanently discolor stainless steel. Wipe up any spills
immediately.
Loading ...
Loading ...
Loading ...