Loading ...
Loading ...
Loading ...
ENGLISH INSTRUCTIONS
12
6. Set a new Oval Vacuum Chamber Seal on the groove in the Plastic Vacuum
Chamber. Work the seal into the groove.
7. Position a new Oval Vacuum Chamber Seal near the groove in the Vacuum Lid.
Work the seal into the groove.
REPLACING THE SEAL BAR TAPE:
*NOTE one extra piece of Seal Bar Tape is included with the original unit as a spare.
1. Turn “OFF” the Vacuum Sealer and remove the Power Cord from the electrical
outlet.
2. Make sure the unit is completely cool.
3. Open the Vacuum Lid.
4. Pick at either end of the Seal Bar Tape covering the Seal Bar Heating Element until
it lifts slightly. Grasp the loose end and slowly pull the Seal Bar Tape back over itself
until fully removed.
5. Repeat step 4 for the Seal Bar Tape covering Vacuum Lid Seal. DO NOT remove
the Seal.
6. Remove the backing from a new wide strip of Seal Bar Tape for the Seal Bar Heating
Element. Be careful not to allow the Seal Bar Tape to contact anything including itself
while the adhesive side is exposed.
7. Hold one end of the Seal Bar Tape in each hand. Stick the left end of the Seal Bar
Tape to the at area on the Plastic Vacuum Chamber just left of the Seal Bar Heating
Element. Apply the Seal Bar Tape from left to right over the Seal Bar Heating Element
until done. Make sure there are no wrinkles or folds in the Seal Bar Tape once applied.
The Seal Bar Tape should fully cover the Seal Bar Heating Element.
8. Remove the backing from a new narrow strip of Seal Bar Tape for the Vacuum Lid
Seal. Stick the left end of the Seal Bar Tape onto the left end of the Seal. The Seal Bar
Tape and Seal ends should be ush. Apply the Seal Bar Tape from left to right over
the Vacuum Lid Seal until done. Make sure there are no wrinkles or folds in the Seal
Bar Tape once applied. The Seal Bar Tape should fully cover the Vacuum Lid Seal.
REPLACING THE FUSE
If the Vacuum Sealer does not operate when it is plugged in
and turned on, try any or all of the following:
1. Make sure the Fuse is not blown. The Fuse is located on
the right side of the unit directly above the Power Cord Port.
Turn “OFF” and unplug the Vacuum Sealer. Twist off and
remove the Fuse Cap. Remove and check the Fuse. The
thin metal band in the center of the Fuse should be clean and
unbroken. If it is burned and/or broken, replace it with a new
Fuse (10 Amp). Replace the Fuse Cap.
2. Make sure the Connector at the end of the Power Cord is
plugged completely into the Power Cord Port.
3. Make sure the Power Cord is not damaged. DO NOT use
a damaged Power Cord. Call the Customer Service line for
information on part replacement.
4. Try connecting the Power Cord Plug to another electrical
outlet.
FIGURE 5
Loading ...
Loading ...
Loading ...