Loading ...
Loading ...
Loading ...
16
CLEANING
Your purifier should be cleaned at least monthly to keep it running at peak
performance, but more often if its operating environment is heavily contaminated.
Cleaning the Purifier (Exterior):
Wipe down the exterior with a damp cloth or use compressed air or a vacuum
cleaner to remove dust.
Cleaning the FILTER ASSEMBLY
You may use clean water or compressed air to clean your FILTER ASSEMBLY once it
has been disassembled (see “DISASSEMBLY” on page 12). After disassembling your
purifier, the three filters (mesh, foam and honeycomb) should be removed and
cleaned separately. If using water, you must allow the filters to dry separately before
reassembly. When reassembling, the Honeycomb Filter goes in first, then the Foam
Filter, and finally the thin Mesh Filter. Lastly, reattach the rim to the FILTER ASSEMBLY.
Cleaning the IONIZATION NEEDLE
Using a cotton applicator (Q-tip), apply a small amount of clear alcohol-based
cleaner (or rubbing alcohol) to the IONIZATION NEEDLE. You may also use compressed
air to blow off any dust that may accumulate near the IONIZATION NEEDLE.
Cleaning the PCO CELL
Using a compressed air or a vacuum cleaner, blow and/or vacuum the dust out of
the PCO CELL. Do not use any liquid to clean the PCO CELL. Do not disassemble the
PCO CELL.
Cleaning the PURIFICATION PLATE
Using white vinegar or a solution of equal parts warm water and clear ammonia, soak
the PURIFICATION PLATE for 8-10 hours but do not exceed 12 hours. Using a soft-bristle
brush, scrub the wire mesh to remove debris. Rinse thoroughly. Alternatively, use an
Ozone Plate Cleaning Kit. Allow the PURIFICATION PLATE to dry completely before
reinstalling. Use a soft cloth and rubbing alcohol to clean the contacts on the interior
of the purifier that touch the PURIFICATION PLATE.
Cleaning the Purifier (Interior)
Using a damp cloth, a clear alcohol-based cleaner, compressed air or a vacuum
cleaner, carefully clean the walls and components inside of the purifier only after
completing the disassembly procedures found in DISASSEMBLY on pages 12 - 13.
Resetting the “PERFORM CLEANING” Maintenance Reminder
To reset the “PERFORM CLEANING” maintenance reminder, press and hold the
REMINDER RESET BUTTON until the reminder goes away. It will return after 30 days of use.
Loading ...
Loading ...
Loading ...