Loading ...
Loading ...
Loading ...
15
ASSEMBLY
Installing the FILTER ASSEMBLY:
1. Hold the FILTER ASSEMBLY with the larger flat side (where the honeycomb layer of
the filter is visible) facing the interior of the purifier.
2. Insert the bottom of the FILTER ASSEMBLY into the tabs on the rear of the purifier
and then seat the FILTER ASSEMBLY on the rear of the purifier. (NOTE: If the user
fails to insert the FILTER ASSEMBLY into the tabs appropriately, disassembling the
purifier in the future could be extremely difficult.)
3. Screw the two BRASS THUMBSCREWS into their holes at the top corners of the
FILTER ASSEMBLY.
Installing the REAR COVER:
1. Place the tabs at the top of the REAR COVER into the holes above the top of the
FILTER ASSEMBLY then swing the REAR COVER flat against the rear of the purifier
and press until the tabs on the inner sides of the REAR COVER click into place in
the purifier.
2. Carefully insert the REAR COVER SCREW into its hole on the REAR COVER (above
the POWER CORD Port) and tighten.
Installing the POWER CORD:
1. Insert the DC POWER ADAPTER PLUG into the rear of the purifier.
2. Ensure the POWER CORD is properly connected to the DC POWER ADAPTER.
3. Insert the POWER CORD PLUG into a wall outlet.
Turning the purifier on:
1. Press the POWER BUTTON.
2. The purier will be set to NORMAL MODE (PCO) once again. Ensure that the purier’s
settings are adjusted to suit your preferences (see “CONTROLS” on page 11).
Loading ...
Loading ...
Loading ...