Loading ...
Loading ...
Loading ...
10
INITIAL SETTINGS
Before using your pureAir 3000 you will need to find the area (or square footage) of
the environment. To do this accurately, take into account all connected rooms with
open doorways (the purification does not flow through closed doors). The pureAir
3000 can purify up to 3,000 square feet of space.
For example: Suppose you have a 2500 square foot house. The living room is attached
to the kitchen, three bedrooms, the den and a laundry room. The kitchen and three
bedrooms’ doors remain open the majority of the time but the laundry room and
den usually remain closed off from the rest of the house. Together, the laundry room
and den have a combined area of 500 square feet. The area of the environment you
would want to set your pureAir 3000 to purify would be 2000 square feet.
Once you have determined an ideal location for your purifier and calculated the
area of the environment:
1. Connect the POWER CORD to the DC POWER ADAPTER and the DC POWER
ADAPTER PLUG into the purifier. (Check to be sure your power supply is properly
assembled. The POWER CORD should be inserted far enough into the DC POWER
ADAPTER so that a space of only about 1/8 in. is left between the widest part of
the POWER CORD and the edge of the DC POWER ADAPTER.)
2. Insert the Power Plug into the wall outlet.
3. Turn the purifier on and set it to NORMAL MODE (PCO) (see CONTROLS)
4. Leave the purifier on NORMAL MODE (PCO) for at least 24 hours to begin with.
5. After 24 hours, set the purifier to HIGH MODE and set the square footage to 250
square feet.
6. Gradually increase the square footage setting every 12 - 24 hours until you
reach the accurate square footage of your area which you calculated in
the beginning steps). Note: Using the purifier at a setting less than the square
footage of the area being treated is acceptable and may be desirable in an
environment relatively free of pollutants.
7. Use your nose to confirm the proper square footage setting. If the setting is
too low, you may notice musty, cooking, animal, or other types of odors. If the
setting is too high, you may notice an oxidation smell which some liken to the
smell of chlorine. In either case, adjust the square footage on the DISPLAY using
the PURIFIER LEVEL CONTROL up or down by 250 ft
2
until the only smell you notice
is a clean, fresh living space.
Loading ...
Loading ...
Loading ...