User Manual Insignia NS-RTM18WH7 18 Cu. Ft. Top-Freezer Refrigerator

Insignia NS-RTM18WH7 18 Cu. Ft. Top-Freezer Refrigerator - Use Manual - Use Guide PDF.
Documents: Go to download!

• Owner's manual - (English)

Table of contents

• Features
• Setting up your refrigerator
• Using your refrigerator
• Reversing the door position
• Maintaining your refrigerator
• Shutting down your refrigerator - long vacations (several months)
• Moving your refrigerator
• Tips on saving energy
• Troubleshooting

User Guide for Refrigerator

Features

• 18 cubic foot capacity
• Electronic control
• Glass spill-safe shelves
• Humidity-controlled crisper drawers
• LED lighting
• Frost free

Main components

Setting up your refrigerator

Before using your refrigerator

1. Remove the interior packing.
2. Let the refrigerator stand upright for approximately four hours before connecting it to power. This reduces the possibility of a malfunction in the cooling system from improper handling during transportation.
3. Clean the interior surface with lukewarm water using a soft cloth.
4. Wait for approximately 24 hours after the thermostat has been set before placing any food in your refrigerator.

Finding a suitable location

• This refrigerator is designed to be free standing only.
• Place your refrigerator on a floor that is strong enough to support the refrigerator when it is fully loaded.
• Locate the refrigerator in your home or garage away from direct sunlight because it may affect the acrylic coating and heat sources may increase electrical consumption. To ensure optimal performance, install in areas with an ambient temperature between 41°F (5°C) and 109°F (42.8°C).
• Avoid locating the refrigerator in moist areas.
• The refrigerator door must be able to swing fully open.

Leveling your refrigerator

• It is very important for the refrigerator to be level. If the refrigerator is not leveled during installation, the doors may not close or seal properly, causing cooling, frost, or moisture problems.
• To level your refrigerator, rotate the leveling feet clockwise (to raise) the refrigerator or counter-clockwise (to lower).

Note Having someone push against the top of the refrigerator helps to take some weight off the leveling foot, making it easier to adjust.

Providing proper ventilation

Place the refrigerator at least one inch from the wall on each side to ensure proper airflow to the compressor. Do not place the refrigerator near any heat sources, such as a heater or stove, as this may put a strain on the compressor.

Providing a proper power supply

Check your local power source. This refrigerator requires a 110V-120V, 60Hz power supply

Use a receptacle that accepts the grounding prong. The power cord is equipped with a 3-prong (grounding) plug which mates with a standard 3-prong (grounding) wall outlet to minimize the possibility of electric shock hazard from this refrigerator.

Notes

• The refrigerator should always be plugged into its own individual electrical outlet which has a voltage rating that matches the rating plate.
• Never unplug your refrigerator by pulling on the power cord. Always grip the plug firmly and pull it straight out from the outlet.

Using your refrigerator

Setting the refrigerator temperature

• The first time you turn the refrigerator on, the control panel LEDs turn on for three seconds, then displays the current setting (default = 3). Your refrigerator runs continuously for several hours until it reaches the preset temperature. After your refrigerator is fully cooled, you can adjust the temperature up or down to your personal preference.
• To temporarily suspend cooling in the refrigerator and freezer, press and hold the SET button for three seconds. The STANDBY LED turns on and cooling is turned off. Press the SET button again to cancel standby mode and resume cooling.

Notes

• If the refrigerator is unplugged or loses power, you must wait three to five minutes before restarting it. If you attempt to restart before this time delay, the refrigerator will not start.
• Large amounts of food will lower the cooling efficiency of the refrigerator.
• If you choose to change the thermostat setting, adjust it by one increment at a time. Allow 24 hours for the temperature to stabilize between adjustments.

Setting the freezer temperature

• Turn the controls to adjust the freezer temperature, allow 24 hours for the freezer to adjust and stabilize.

Using the freezer compartment

• Place frozen food into the freezer as quickly as possible after purchase.
• Follow package instructions regarding storage times. The storage life of frozen foods varies and the recommended storage time should not be exceeded.

Reversing the door position

Based on the location where you plan to use your refrigerator, you may find it more convenient to reverse the position of the door.

Caution To avoid injury to yourself or your property, we recommend that someone assist you during the door reversal process.

Preparing to reverse the door position

Note Images show a refrigerator that initially opens on the left side. However, your refrigerator may open on the right side.

You will need: A standard (flat head) screwdriver and a Phillips screwdriver.

• Make sure that your refrigerator is unplugged and empty.
• Have someone available to assist you in the process.
• Keep all of the parts you remove to reuse them later.

Reversing the door position

Parts included with the hinge kit:

OR

Parts you’ll use that are already mounted on the door (as shipped):

1. Unplug your refrigerator and remove all food from the door shelves.
2. Remove the cover plate and the top hinge cover, then unscrew and remove the top hinge. Keep the screws to reuse.

3 Lift the freezer door up and away from your refrigerator.

4 Unscrew the three screws holding the center hinge, remove the hinge, then lift the refrigerator door up and away from your refrigerator. Save the screws to reuse and store the hinge in a safe place in case you need to reverse the door position again.

5 Unscrew the two screws holding the bottom hinge, then remove the bottom hinge from the refrigerator.

6 Unscrew the hinge pin from the bottom hinge and reattach it to the other hole in the hinge pin, then secure the bottom hinge to the opposite side of the refrigerator using the screws you removed previously.

7 Remove the hole caps and plastic bushings from the top of the freezer and refrigerator doors. Save them for the next step

8 Insert the hole caps and plastic bushings into the opposite sides (from where you removed them) of the freezer and refrigerator doors.

9 Remove the door block from the bottom of the refrigerator door and attach it to the other side.

10 Attach the upper door self-locking block and the door-open stopper to the side of the freezer door where the hinge will be. Use the parts from the hinge kit.

11 Remove the old upper door self-locking block and the door-open stopper (do not remove the parts attached in step 10). Store in a safe place in case you need to reverse the door position again.

12 Attach the refrigerator door to the bottom hinge, then attach the center hinge to the refrigerator. Use the center hinge from the hinge kit (not the piece removed in step 4).

13 Put the freezer door onto the center hinge, then attach the top hinge (from the hinge kit) to the top of refrigerator. Cover the hinge with the top hinge cover (from the hinge kit) and cover the screw holes on the top with the cover plate you previously removed.

14 Add covers to the screw holes and hinge pivot.

Installing an optional ice maker

The refrigerator comes set up for ice maker installation. This refrigerator is compatible with the Insignia NS-IMK20WH7 ice maker.

Maintaining your refrigerator

Your refrigerator is designed for year-round use with only minimal cleaning and maintenance.

When you first receive it, wipe the cabinet with a mild detergent and warm water, then wipe dry with a dry cloth. Do this periodically to keep your refrigerator looking new

Caution

To prevent damage to the finish, do not use:

• Gasoline, benzine, thinner, or other similar solvents.
• Abrasive cleaners.

1. Turn off the refrigerator and unplug it from the wall outlet.
2. Remove all food.
3. Wash the inside with a damp warm cloth soaked in a solution of one quart of lukewarm water to two tablespoons of baking soda solution.
4. Be sure to keep the door gasket (seal) clean to keep the refrigerator running efficiently.
5. Dry the interior and exterior with a soft cloth.

Defrosting the freezer

This refrigerator is frost free, so you don't need to defrost it. You just need to clean it periodically, following the above instructions.

Changing the interior LED light

1. Using a Phillips screwdriver, remove the screw securing the lamp cover, then remove the lamp cover.

2 Remove the LED lightbulb from the lamp base, then install a new LED lightbulb.

3 Reinstall the lamp cover with the screw you previously removed.

Shutting down your refrigerator - long vacations (several months)

1. Turn off the refrigerator and unplug it from the wall outlet.
2. Remove all food.
3. Clean the refrigerator.
4. Leave the door open slightly to avoid possible formation of condensation, mold, or odor.

Caution Use extreme caution with children. The refrigerator should not be accessible to child's play.

Moving your refrigerator

1. Turn off the refrigerator and unplug it from the wall outlet.
2. Remove all food.
3. Securely tape down all loose items inside your refrigerator.
4. Tape the doors shut. Be sure the refrigerator stays in the upright position during transportation.

Tips on saving energy

• Locate your refrigerator in the coolest area of the room, away from heat producing appliances or heating ducts and out of the direct sunlight.
• Let hot foods cool before placing them in the refrigerator. Overloading the refrigerator forces the compressor to run longer. Foods that freeze too slowly may lose quality or spoil.
• Wrap foods properly and wipe containers dry before placing them in the refrigerator. This cuts down on frost build-up inside the refrigerator.
• Organize and label food to reduce door openings and extended searches.

Troubleshooting

Caution Do not try to repair your refrigerator yourself. Doing so invalidates the warranty

Error codes