Loading ...
Loading ...
Loading ...
Programming A Rolling Code
For programming garage door openers that were manufac-
tured after 1995:
These garage door openers can be identified by the “LEARN”
or “TRAIN” button located where the hanging antenna is
attached to the garage door opener. It is NOT the button that
is normally used to open and close the door. The name and
color of the button may vary by manufacturer.
1. Place the ignition in the ON/RUN position.
NOTE: For vehicles equipped with Keyless Enter-N-Go,
place the ignition in the RUN position with the engine ON.
Make sure while programming HomeLink with the engine
ON that your vehicle is outside of your garage, or that the
garage door remains open at all times.
2. Place the hand-held transmitter 1 to 3 inches (3 to 8 cm)
away from the HomeLink button you wish to program
while keeping the HomeLink indicator light in view.
3. Push and hold the HomeLink button you want to
program while you push and hold the hand-held trans-
mitter button.
4. Continue to hold both buttons and observe the indicator
light. The HomeLink indicator will flash slowly and
then rapidly after HomeLink has received the frequency
signal from the hand-held transmitter. Release both
buttons after the indicator light changes from slow to
rapid.
Training The Garage Door Opener
1 — Door Opener
2 — Training Button
78 GETTING TO KNOW YOUR VEHICLE
Loading ...
Loading ...
Loading ...