Loading ...
Loading ...
Loading ...
6
5 6
CYCLE OPTIONS
Use these buttons to select available options for your dryer.
Not all cycles and options are available on all models.
Wrinkle Prevent/Wrinkle Prevent with Steam
(on some models)
If you will be unable to remove a load immediately,
press Wrinkle Prevent to add up to 150 minutes of periodic
tumbling to help reduce wrinkling. On models with Wrinkle
Prevent with Steam, a short steam cycle is added after 60
minutes to help smooth out wrinkles.
Drum Light
Press to turn the drum light on or off. The light will
also turn on when the door is open, and turn off
automatically after about 5 minutes.
Damp Dry Signal
When selected, a signal will sound during the drying
cycle when the load is damp but not completely dry. This
will allow you to take clothes out of the load that do not
need to dry completely. This option is available on Heavy
Duty, Normal, Denim, Bulky, Wrinkle
Control, Sheets, Active Wear, Towels and Delicate cycles.
NOTE: The Damp Dry signal defaults to “ON” when
using the Bulky cycle.
Cycle Signal
Use this button to turn the signal indicating the end
of a drying cycle on or off, or to adjust the volume of
the signal.
NOTE: You may also turn off the tones that sound when a
button is pressed. Press and hold the Cycle Signal button
for about three seconds to turn button sounds
on or off.
Reduce Static (on some models)
Press to add the Reduce Static option to selected Sensor
cycles (see Cycle Guide). The dryer will automatically
tumble, pause, and introduce a small amount of moisture
into the load to help reduce static. This option adds
approximately 8 minutes to the total cycle time.
Steam Boost (on some models)
Steam Boost adds steam to the end of the Heavy Duty,
Bulky, Normal, Sheets, Towels, or Denim cycle to help
smooth wrinkles.
Airflow
This indicator will show the status of airflow through
the dryer during Sensor cycles. The Detecting light comes on
during the sensing phase at the beginning of cycle.
The Good light will come on if no major vent blockage is
detected. The Check Vent light will come on if a blocked
vent or low airflow issue is detected. For more information on
maintaining good airflow, see “Check Your Vent System
for Good Airflow”. The Airflow sensing feature is available for
Sensor cycles only.
NOTE: If there are other error issues during a cycle, the
Airflow indicator will not light up. See “Dryer Displaying Code
Message” in “Troubleshooting”section.
Steam (on some models)
This indicator will light when the Steam function is active.
NOTE: Steam options are not available on all models
or on all cycles.
Done
This will indicate that the selected cycle has ended and the
load may be removed from the dryer. If the Wrinkle Prevent
option has been selected, the dryer may continue to tumble
the load, even if the DONE indicator is lit.
Check Lint Screen
The Check Lint Screen indicator will light when the drying
cycle is complete as a reminder to clean the lint screen.
Wrinkle Prevent
This indicator will light if the Wrinkle Prevent option
has been selected and is running. The dryer will continue
to periodically tumble the load for up to 150 minutes
(depending on model and selected settings) after the
cycle has ended.
Steam model shown
LED DISPLAY AND SETTINGS BUTTONS
When you select a cycle, its default settings will light up and
the Estimated Time Remaining (for Sensor Cycles) or actual
time remaining (for Timed Cycles) will be displayed.
Use the buttons along the bottom of the display to adjust
settings. See “Cycle Guide” for available settings on each
cycle. Not all settings are available with all cycles.
Loading ...
Loading ...
Loading ...