Loading ...
Loading ...
Loading ...
8
Style 2: Direct wire strain relief
■ Use Phillips screwdriver to remove screws and slide cord/
conduit plate down and out.
■ Position cord/conduit plate as shown in the following
illustration.
■ Replace cord/conduit plate and insert screws.
■ Assemble a UL Listed conduit connector in the opening.
■ Feed the exible conduit through the strain relief,
allowing enough slack to easily attach wiring to the
terminal block.
■ Tighten strain relief screw against the exible conduit.
5. Replace back panel and screws on rear of range.
6. Complete installation following instructions for your type of
electrical connection:
4-wire (recommended)
3-wire (if 4-wire is not available)
Electrical Connection Options
If your home has: And you will be
connecting to:
Go to Section:
4-wire receptacle
(NEMA type 14-50R)
A UL Listed,
250-volt
minimum,
40-amp, range
power supply
cord
4-Wire Connection:
Power Supply Cord
4-wire direct A fused
disconnect or
circuit breaker
box
4-Wire Connection:
Direct Wire
3-wire receptacle
(NEMA type 10-50R)
A UL Listed,
250-volt
minimum,
40-amp, range
power supply
cord
3-Wire Connection:
Power Supply Cord
3-wire direct A fused
disconnect or
circuit breaker
box
3-Wire Connection:
Direct Wire
A
B
A. Removable retaining nut
B. Strain relief
(12.7 cm)
5"
3"
(7.6 cm)
1"
(2.5 cm)
Loading ...
Loading ...
Loading ...