Loading ...
Loading ...
Loading ...
19
TROUBLESHOOTING – WASHER (CONT.)
Washer won’t run or ll;
washer stops working
(cont.)
Check proper electrical supply. Plug power cord into a grounded 3 prong outlet.
Do not use an extension cord.
Ensure there is power to outlet.
Reset a tripped circuit breaker. Replace any blown fuses.
NOTE: If problems continue, contact an electrician.
Normal washer operation. Lid must be closed for washer to run.
Washer will pause during certain phases of cycle. Do not
interrupt cycle.
Washer may be stopped to reduce suds.
Washer may be tightly packed. Remove several items, rearrange load evenly around the
washplate. Close lid, press START/PAUSE button.
Add only one or two additional items after washer has started.
Do not add more water to the washer.
Not using HE detergent or using too
much HE detergent.
Only use HE detergent. Suds from regular detergents can slow or
stop the washer. Always measure detergent and follow detergent
directions based on your load requirements.
To remove suds, cancel cycle. Select Rinse then Spin. Do not
add more detergent.
Washer not draining/
spinning; loads are
still wet
Small items may have been caught
in pump or between basket and tub,
which can slow draining.
Empty pockets and use garment bags for small items.
Using cycles with a lower spin speed. Cycles with lower spin speeds remove less water than cycles
with high spin speeds. Use the recommended cycle/speed spin
for your item.
Washer may be tightly packed or
unbalanced.
Tightly packed loads may not allow the washer to spin correctly,
leaving the load wetter than normal. Evenly arrange the wet load
for balanced spinning. Select SPIN to remove excess water.
See “Using Your Washer” for loading recommendations.
If you experience Possible Causes Solution
Washer not performing as expected (cont.)
Washer won’t run or ll;
washer stops working
Check for proper water supply. Hose(s) must be attached and have water owing to inlet valve.
Water faucet(s) must be turned on.
Check that inlet valve screens have not become clogged.
Check for any kinks in inlet hoses, which can restrict water ow.
First try the solutions suggested here or visit our website at www.whirlpool.com/product_help –
In Canada www.whirlpool.ca for assistance and to possibly avoid a service call.
Loading ...
Loading ...
Loading ...