Loading ...
Loading ...
Loading ...
17
AVOID SERVICE CHECKLIST
Before you call for service, review this list. It may save you time and expense. The list includes common occurrences
that are not the result of defective workmanship or materials in this appliance.
This oven is equipped with an electronic oven controller (some models). Among its many features is a full time oven
circuit diagnostics system. The controller constantly monitors its internal circuitry as well as several crucial oven circuits,
to insure they are all operating correctly. If at any time one of these systems fail, the controller will immediately shut
down operation, and will beep and ash an error code of -F1-, -F3- or -F9- in the display window.
BEFORE YOU CALL
OCCURRENCE POSSIBLE CAUSE/SOLUTION
Oven Control Beeps and Displays
any F code error ( example: -F1-
-F3- or -F9-).
Electronic control has detected a fault condition. Press STOP/CLEAR to clear
the display and stop the beeping. Reprogram the oven. If a fault reoccurs,
record the fault number. Press STOP/CLEAR and call Service center or
another qualied servicer.
Installation - Oven is not level. Place oven rack in center of oven. Place a level on the oven rack. Contact
installing agent if rack and cabinet cutout ooring are not level.
Kitchen cabinet misalignment may make oven appear to be not level. Be sure
cabinets are square and level. Contact cabinet maker to correct problem.
Entire appliance does not
operate.
Make sure cord / plug is securely plugged into electrical outlet.
Cord/plug is not installed and/or connected. Cord is not supplied with oven.
Contact your dealer, installing agent or authorized servicer.
Service wiring not complete. Contact your dealer, installing agent or authorized
servicer.
Power outage. Check house lights to be sure. Contact your local electric company.
Short in cord/plug. Replace cord/plug.
Controls are not set properly. See instructions to set the controls.
House fuse has blown or circuit breaker has tripped immediately following
installation. House fuse may not be fully engaged. Check fuse and screw or
engage circuit breaker securely.
House fuse has blown or circuit breaker has tripped after the oven has been
installed and previously operating. Call an authorized servicer.
Wall oven is not properly connected to gas supply. Check connection (see
installation instructions).
Make sure both the built-in regulator gas valve and the the external shut-off
valve are turned on (see installation instructions).
The time of day not set. The time of day must be set rst in order to operate
the oven.
Oven light does not work. Burned-out or loose bulb. Follow instructions under Changing Oven Light to
replace or tighten the bulb.
Loading ...
Loading ...