Loading ...
Loading ...
Loading ...
13
Read Before
Using
If the refrigerator is installed
directly on carpet or other mats, the
compressor under the refrigerator
may touch the mat, causing
discoloration of the mat, or may
interfere with the cooling capability
by reducing air flow.
INSTRUCTIONS FOR INSTALLATION
Refrigerator should be installed on a firm and
level floor.
1
Install in a low-humidity location.
5
Place a firm board under the refrigerator when
installing it on a weak floor, on a tatami, or on
a carpet.
2
If the refrigerator is tilted, adjust with leveling
screws under the front end. The front end of the
refrigerator should be slightly higher so the door will
close when lightly pushed.
3
To avoid electric shock, ground the refrigerator.
7
Install away from heat sources.
4
Do not put anything in front of the grille.
8
If the floor is not firm, noise
or vibration may occur. When
opening and closing the door,
the refrigerator may topple and
cause injuries.
An electrical short circuit or rusting may occur. If it is necessary
to install in a washroom or on a damp floor, be sure to provide
gaps by placing the refrigerator on some sort of blocks.
CAUTION: This type of refrigerator uses
forced fan cooling. Therefore, to prevent
reduction in the cooling capacity, place the
refrigerator on top of a firm board before
placing it on blocks. Do not place the
refrigerator directly on top of the blocks.
Avoid locations in direct sunlight
or near heat-producing appliances
(range, heater, etc.). Cooling
efficiency may be lowered or
external color changes may result.
Straight!
Consult dealer for grounding
installations. (Fee will be charged
for grounding installations.)
NOTE: A grounding wire is
attached to this refrigerator.
Please connect these grounding
terminals correctly.
Since air is suctioned in from
the front of the grille, obstructing
the grille could lower the cooling
capacity.
Leveling Screws
Rotate
clockwise
to raise
Rotate
clockwise
to raise
Allow sufficient space around the refrigerator as
shown in diagrams below.
6
Units: mm
Wall Outlet
Icemaker
50~100
X = 16 (TFJ20/22/25), = 3 (TPJ24, TFJ28/30)
Y = 25 (TFJ20/22/25), = 13 (TPJ24, TFJ28/30)
Z = 25 (TFJ20/22/25, TPJ24), = 3 (TFJ28/30)
50~100
50~100
Y
50
Y
Z
X X
X X
Stop Valve
for Icemaker
if installed
Stop Valve for
Icemaker
If Icemaker is installed
Loading ...
Loading ...
Loading ...