Loading ...
Loading ...
Loading ...
5
INSTALLATION INSTRUCTIONS
Before Using Your Appliance
Remove the exterior and interior packing.
Before connecting the appliance to the power source, let it stand upright for approximately 2 hours. This will
reduce the possibility of a malfunction in the cooling system from handling during transportation.
Clean the interior surface with lukewarm water using a soft cloth.
Install the handle on the left side of the door using the screws that are provided.
Installation of Your Appliance
This appliance is designed for free standing or built-in (fully recessed) installation. If free standing, the unit
should have at least 4” of clearance at both sides, at the top and at the back to allow for adequate ventilation.
If it is built-in, leave 3/16” at both sides, 1/16” at the top and 2” at the rear. Be sure that airflow under the
appliance is not blocked.
Place your appliance on a floor that is strong enough to support it when it is fully loaded. To level your
appliance, adjust the front leveling legs at the bottom.
Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct
sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Extremely cold
ambient temperatures may also cause the unit not to perform properly.
Avoid locating the unit in moist areas.
Plug the appliance into an exclusive, properly installed and grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning power
and/or grounding should be directed toward a certified and authorized products service center.
The handle is stored inside the unit. Install using the screws (supplied).
Reversing the Door Swing
This appliance has the capability of the door opening from either the left or right side. The unit is delivered to you
with the door opening from the left side. Should you desire to reverse the opening direction, please follow the
instructions below. To make the reversal, you will find two hardware pieces in a plastic bag inside the appliance:
the top left hinge and the bottom left hinge. The bottom support bracket is used for both sides.
1. Carefully lay the appliance on its back. Use cushioning to protect the floor and appliance.
2. Using a Phillips screwdriver, remove the two screws and bottom right hinge beneath the door. Keep the
hinge in a safe place in case you need to reverse the door again in the future.
3. Carefully slide the door off and place it on a padded surface.
4. Interchange the plastic shaft sleeves at the top of the door.
5. Remove the bottom support bracket from the right side.
6. Remove the top right hinge and keep in a safe place in case you want to reverse the door in the future.
7. Remove the screws from the top left and transfer to the right.
8. Install the top left hinge.
9. Install the bottom left hinge to the door. Do not over-tighten the screw.
10. Place the door back on the appliance, lining up the top hinge.
11. Install the bottom support bracket.
12. Adjust door alignment. When set, tighten screw on hinge.
13. Remove handle. Transfer the screw hole covers to the left and install the handle on the right.
Loading ...
Loading ...
Loading ...