Loading ...
2 / 4
K
U
(2x)
bottom
hole
Remove battery cover and battery pack from interior assembly.
Install 4 AA batteries in battery pack.
Install interior assembly onto mounting plate.
Press and HOLD the Lock button
while installing battery pack.
Hold button until the latch bolt
starts moving on its own.
Did the latch bolt retract and extend on its own
when the battery pack was installed?
A
A
B
B C
YES NO
or
a
c
b
d
Make sure turnpiece is in
the vertical position.
Door handing process
was successful! Proceed
to next step after latch
bolt stops moving.
Remove battery pack,
wait 15 seconds, then
attempt the process again.
Note: Latch
bolt will only
retract half way.
Make sure
turnpiece shaft is
rotated as shown.
Ensure correct polarity.
For best results, use
new, non-rechargeable
Alkaline batteries only.
Do not install
batteries
until step 5.
Ensure tight cable
connection.
Lay excess cable lat inside the
bottom of the interior housing.
align
L
a
c
b
d
U
actual
size
M
L
L
L
K
3
4
Install the interior assembly
5
Install the batteries and perform the door handing process
This step will teach your lock the orientation of your door and is crucial to lock operation.
21/8"
54 mm
11/2"
38 mm
What is the diameter of the hole in the door?
Locate screws for step 3C and keep them within reach.
Install exterior keypad and mounting plate.
A
B
C
Diameter is 21/8"
(54 mm)
Diameter is 11/2"
(38 mm)
or
“D” is required for installation.
Install “D” on “F”.
“D” is not needed for
installation. Discard “D”.
Cable goes
underneath latch.
Support exterior
assembly during
mounting plate
installation.
Route cable through
center hole, then push
cable into bottom hole.
Insert key and
test latch. If latch
does not extend or
retract smoothly,
adjust screws (T).
Remove key when
inished and make
sure the latch bolt
is fully extended.
Keep parallel to
edge of door.
Tighten
screws evenly.
a
c
b
d
actual
size
T
D
D
F
F
G
T
T (2x)
T
E
Install the exterior keypad
Loading ...
Loading ...