Loading ...
Loading ...
Loading ...
INSTALLATION INSTRUCTIONS
1. Remove all packing materials from the oven cavity, (do not remove the waveguide cover), and the feature
sticker from the outside of the door, if there is one. Check the unit for any damage, such as a misaligned door,
damaged door seals around the door or dents inside the oven cavity or on the door. If there is any damage,
please do not operate the oven until it has been checked by a SERVICE CENTRE APPROVED BY SHARP
and repaired, if necessary.
2. Accessories provided
1) Turntable 2) Turntable Ring 3) Rack 4) Combined operation manual and cookbook
3. Since the door may become hot during cooking, you should place or mount the oven so that the bottom of
the oven is 85 cm or more above floor. You should also keep children away from the door to prevent them
burning themselves.
This oven is designed to be used on a countertop, in a cabinet or built-in(not available in all countries).
It should not be installed in any area
where excessive heat and steam are generated, for example,
next to a conventional oven unit. The oven
should be installed so as not to block ventilation openings.
For R-890E(W)/(ST)/(BS): Allow a space of at least 40cm on the top, 5cm on both sides and at the rear of the
WARNING: The electrical outlet must be readily accessible so that the unit can be unplugged easily in
an emergency.
4. Neither the manufacturer nor the distributors can accept any liability for damage to the machine or personal
injury for failure to observe the correct electrical connecting procedure.
The A.C. voltage must be single phase 230-240V, 50Hz.
5. This appliance must be earthed.
6. Operate the oven from a general purpose domestic outlet. If a generator is used, do not operate the oven with
non-sinusoidal outputs.
7. Before using the grill for the first time, operate the oven without food for 20 minutes.
This will allow the oil that is used for rust protection to be burned off.
oven for adequate air circulation. When installing in a cabinet, the minimum inside dimension of the cabinet
should be 620mm(W) x 715mm(H) x 560mm(D).
4
Loading ...
Loading ...
Loading ...