Loading ...
Loading ...
Loading ...
Operating the appliance en
9
Sensor control
In automatic mode, a sensor in the extractor hood
detects the intensity of the cooking and roasting
odours. Depending on the sensor setting, the fan
automatically switches to another fan setting.
Default sensitivity setting: „
Lowest sensitivity setting: ‚
Highest sensitivity setting: †
If the sensor control responds too quickly or too slowly,
it can be changed accordingly:
1. When the fan is switched off, hold the ! symbol
for approximately four seconds. The setting is
displayed.
2. The sensor control setting can be changed by
sliding your finger to the right or to the left across the
||| settings range.
3. To confirm the entry, hold the ! symbol for
approximately four seconds.
Lighting
The lighting can be switched on and off independently
of the fan.
Touch the = symbol.
Setting the brightness
Press and hold the = symbol until the desired
brightness is reached.
Saturation display
When the metal grease filters or the activated charcoal
filter are/is saturated, an audible signal sounds for
approximately four seconds after the fan is switched off.
In addition, the corresponding symbol appears on the
display:
■ Metal grease filter:!
■ Activated charcoal filter: "
If you have not yet done so, the metal grease filters
should be cleaned or the activated charcoal filter
changed.
For instructions on how to clean the metal grease filters,
please refer to the section ~ "Cleaning and
maintenance" on page 10.
The saturation indicators can be reset while they are
flashing. To do this, touch the - symbol.
Switching over the indicator for circulating-air mode
For circulating-air mode, the electronic control must be
switched over accordingly:
■ The extractor hood must be connected and switched
off.
■ Touch and hold the # and ! symbols at the
same time, until the ™" indicator lights up for
circulating-air mode "Starter Set". Repeatedly
pressing and holding this button combination
causes the ’" indicator to light up for the
"CleanAir" circulating-air module.
■ Repeatedly pressing and holding this button
combination switches the electronic control back
over to ducted operation (! indicator).
Audible signal
Switching on the audible signal
When the fan is switched off, press and hold the # and
+ symbols simultaneously for approximately three
seconds. An audible signal sounds as an
acknowledgement.
Switching off the audible signal
Repeat the "Switching on the audible signal" process.
Loading ...
Loading ...
Loading ...