Loading ...
Loading ...
Loading ...
Operating the appliance en
7
1Operating the appliance
Oper at i ng the appl i anc e
These instructions apply to several appliance variants.
It is possible that individual features are described
which do not apply to your appliance.
Note: Switch on the extractor hood when you start
cooking and switch it off again several minutes after you
have finished cooking. This is the most effective way of
removing the kitchen fumes.
Control panel model 1
Setting the fan
Switching on
■ Pull out the filter pull-out and touch the # symbol.
The fan will start at setting ƒ.
■ Touch the + or - symbol to alter the fan speed.
Note: When the filter pull-out is pushed in, only fan
settings ‚, ƒ and „ can be selected.
Switching off
Touch the # symbol. Slide in the filter pull-out.
Intensive setting
You can use the intensive setting if there is a large
build-up of odours and fumes/vapours.
Touch the + symbol whilst the fan is at setting „.
This activates intensive setting ‚ 2. Touch the +
symbol once again to activate intensive setting ƒ2.
After approximately six minutes, the electronics
automatically reduce the fan to a lower setting . If you
want to end the intensive setting before the preset time
expires, touch the - symbol until the required fan setting
is reached.
Boost function
The boost function is a short-term maximum power
setting which can be activated at any fan setting.
Touch the & symbol. After approximately 20 seconds,
the fan switches back to the previously set fan setting.
Fan run-on time
Touch the x symbol or slide in the filter pull-out while
the extractor hood is operating.
After approximately 10 minutes, the fan will switch off
automatically.
Lighting
The lighting can be switched on and off independently
of the fan.
Touch the = symbol.
Setting the brightness
Press and hold the = symbol until the desired
brightness is reached.
Saturation display
When the metal grease filters or the activated charcoal
filter are/is saturated, an audible signal sounds for
approximately four seconds after the fan is switched off.
In addition, the corresponding symbol appears on the
display:
■ Metal grease filter:!
■ Activated charcoal filter: "
If you have not yet done so, the metal grease filters
should be cleaned or the activated charcoal filter
changed.
For instructions on how to clean the metal grease filters,
please refer to the section ~ "Cleaning and
maintenance" on page 10.
The saturation indicators can be reset while they are
flashing. To do this, touch the - symbol.
LQW
Explanation
#
Fan on/off
=
Light on/off/dimming
- Reduces the fan settings/fan run-on time
+ Increases the fan settings/intensive setting 1, 2
&
Boost function (short-term maximum power)
x
Fan run-on
Loading ...
Loading ...
Loading ...