Loading ...
Loading ...
Loading ...
14
49-80549-4
3
INSTALL DUCT BRACKET
The duct bracket should be installed against the back wall
DQGIOXVKZLWKWKHFHLOLQJWKHSRLQWZKHUHWKHFHLOLQJPHHWV
the wall should be level for the bracket and duct cover to fit
flush. This bracket will hold the duct cover in place at the top.
6HFXUHWKHEUDFNHWWRWKHZDOO
• Align the diamond centerline cutout on the bracket with the
penciled centerline on the wall.
• Mark 2 screw hole locations in the wall.
'ULOOµSLORWKROHVLQWKHPDUNHGORFDWLRQV
• If pilot holes do not enter wood studs, enlarge the holes to
µDQGLQVWDOOPHWDOZDOOIDVWHQHUDQFKRUVSURYLGHG
• If mounting directly to a masonry wall, obtain appropriate
#10 masonry screw anchors. Drill and install per the
fastener supplier’s instructions.
• Drive screws, by hand, into the fasteners to allow anchors
WRH[SDQG5HPRYHWKHVFUHZV
6HFXUHWKHEUDFNHWWRWKHZDOOZLWKZRRGVFUHZVDQGRU
fasteners.
2
INSTALL HOOD MOUNTING SCREWS
The two upper mounting screws must enter the horizontal
support or wall studs.
• With the template taped in place, use a punch to mark
mounting bracket screw locations.
'ULOOµSLORWKROHVLQRIWKHSXQFKHGORFDWLRQVLQWKH
lower bracket. If the bottom 2 pilot holes do not enter
ZRRGHQODUJHWKHKROHVWRµDQGLQVWDOOPHWDOZDOO
fastener anchors (provided).
• Remove the template.
,QVWDOOWKHWRSPRXQWLQJVFUHZVOHDYHµJDSEHWZHHQ
the screw head and the wall. This will allow the keyhole slot
on the hood frame to engage the screw head.
IMPORTANT: Use the mounting screws provided.
DO NOT USE DRYWALL SCREWS.
• Check to be sure the mounting screws are horizontally
level.
Centerline cutout
4
MOUNT THE HOOD
WARNING
2 people are required to lift and position the
hood onto the mounting screws.
• Lift the hood onto the mounting screws.
• If using a wall fastener, make sure the washer is in front
of the flange and not behind it. Check with a level before
tightening the screws.
• Install lower screws to pull the hood tight against the wall.
Tighten
screws
Install
screws
REAR WALL
MOUNTING TEMPLATE
Vertical Centerline
ALIGN BOTTOM EDGE
WITH PENCIL LINE
INDICATING BOTTOM
OF THE HOOD
11-7/16"
Installation Height
Horizontal Line
C
L
DRILL 2 (TWO) 3/16" PILOT HOLES THROUGH STUDS OR REAR WALL SUPPORT
10-1/8"
12-08 JR
2"
DRILL 2 (TWO) 3/16" PILOT HOLES THROUGH STUDS OR REAR WALL SUPPORT
12-1/2"
WALL VENT IS 27-3/4" MIN.
ABOVE THE INSTALLATION
HEIGHT
31-14772 Printed in Mexico
Bottom
screw
location
,167$//$7,21³9(17('727+(2876,'(
Installation Instructions
Loading ...
Loading ...
Loading ...