Loading ...
Loading ...
Loading ...
19
TROUBLESHOOTING
If you experience Possible Causes Solution
Error Code Appears in Display
“LF” (F8E1) (too long
to fill) appears in display
Washer taking too long to fill. Drain
extends more than 4.5" (114 mm)
into standpipe.
Check plumbing for correct drain hose installation. Use drain hose
form and attach securely to drainpipe or tub. Do not tape over drain
opening. See Installation Instructions.
F#E# code (F-type error
code) appears in display
System error code. Touch POWER to clear the code and exit cycle. Then touch
POWER, select cycle, and touch and hold the Start/Pause button
to start washer. If code appears again, call for service.
F1E1 ACU (Appliance
control fault)
Internal ACU failure. Call for service.
F2E3 UI/ACU mismatch ACU/UI initialization error. Call for service.
F3E1 Water level sensing
failure
Pressure sensor on ACU failure. Call for service.
F5E2 Lid lock will not lock
if lid lock failure
An item in the load may be keeping
the lid from locking.
Check for items directly under the lid.
F5E3 Lid cannot unlock Objects on washer lid prevent it from
unlocking.
Remove objects, such as baskets of laundry, from top of washer.
F6E2 or F6E3
Communication Error:
UI cannot communicate
ACU or UI synchronization error. Remove power from the washer. Let washer set for 5 minutes
for the washer to completely power down. Apply power to washer
and check for error codes. If the error code persists call for service.
F8E6 (Lid opened)
appears in display
Washer lid left open. Close the lid and touch POWER to clear the display. If the lid is left
open for more than 10 minutes, the cycle will reset and water in the
washer will drain.
“drn” “dr” (F9E1)
(drain pump system
problem – long drain)
appears in display
Washer taking too long to drain water.
Drain extends more than 4.5" (114 mm)
into standpipe.
Check plumbing for correct drain hose installation. Use drain hose
form and attach securely to drainpipe or tub. Do not tape over drain
opening.
Lower drain hose if the end is higher than 96" (2.4 m) above
the floor. Remove any clogs from drain hose. See Installation
Instructions.
“Ofb” (Off Balance) Load not balanced or evenly
distributed around the basket.
Cycle is paused as indicated by the flashing Start/Pause
indicator. Open the lid, redistribute the load, and close the lid.
Touch and hold the Start/Pause button to resume.
First try the solutions suggested here or visit our website at www.maytag.com/product_help –
In Canada www.maytag.ca for assistance and to possibly avoid a service call.
Loading ...
Loading ...
Loading ...