Loading ...
Loading ...
Loading ...
17
TROUBLESHOOTING
First try the solutions suggested here. If you need further assistance or more recommendations that may help you avoid
a service call, refer to the warranty page in these instructions, or visit producthelp.www.whirlpool.com. In Canada, visit
www.whirlpool.ca
Contact us by mail with any questions or concerns at the address below:
In the U.S.A.:
Whirlpool Brand Home Appliances
Customer eXperience Center
553 Benson Road
Benton Harbor, MI 49022-2692
In Canada:
Whirlpool Brand Home Appliances
Customer eXperience Centre
200 - 6750 Century Ave.
Mississauga, Ontario L5N 0B7
Please include a daytime phone number in your correspondence.
Problem Possible Causes and/or Solutions
Nothing will operate
Power supply cord is unplugged: Plug into a grounded outlet.
Household fuse is blown or a circuit breaker is tripped: Replace the fuse or reset the circuit breaker. If the
problem continues, call an electrician.
The control displays an F9 or F9 E0 error code: The electrical outlet in the home may be miswired. Contact
a qualified electrician to verify the electrical supply.
Cooktop will not
operate
The control knob is not set correctly: Push in knob before turning to a setting.
On ceramic glass models, the oven control lockout is set: See “Control Lock” in the “Feature Guide”
section.
Excessive heat
around cookware
on cooktop
Cookware is not the proper size: Use cookware about the same size as the surface cooking area, element,
or surface burner. Cookware should not extend more than 1/2" (13 mm) outside the cooking area.
Cooktop cooking
results not
what expected
Control knob set to incorrect heat level: See the “Cooktop” section.
Range is not level: Level the range. See the Installation Instructions.
Cooktop element
cycles on and off
on Hi setting
Element cycling due to a temperature limiter: This is normal operation. The element may cycle on and off to
keep the cooktop from overheating.
Oven will not operate
Delay Start is set: See the “Electronic Oven Controls” section.
Control lock is on: Press and hold CONTROL LOCK for 3 seconds to unlock.
Control is in Demo mode: Demo mode will deactivate all oven elements. See “Demo Mode” in the “Electronic
Oven Controls” section.
Electronic oven control set incorrectly: See the “Electronic Oven Controls” section.
Oven temperature
too high or too low
Oven temperature needs adjustment: See “Oven Temperature Control” in the “Electronic
Oven Controls” section.
Oven indicator
lights flash
Power to range is turned on or restored: See “Control Display” in the “Electronic Oven Controls” section. If
the indicator lights keep flashing, call for service.
Display shows
messages
Power failure (display shows flashing time): Clear the display. On some models, reset the clock, if needed.
See “Clock” keypad feature in the “Feature Guide” section.
Error code (display shows letter followed by number): Depending on your model, press the Cancel keypad
to clear the display. See “Control Display” in the “Electronic Oven Controls” section. If it reappears, call
for service.
Loading ...
Loading ...
Loading ...