Loading ...
Loading ...
Loading ...
4
INSTALLATION INSTRUCTIONS
Remove Mounting Plate
Depending on your model, the mounting plate may be in
the foam packaging or it may be attached to the back of
the microwave oven.
NOTE: To avoid possible damage to the work surface, cover the
work surface.
1. Remove any remaining contents from the microwave oven
cavity.
2. If the mounting plate is attached to the back of the microwave
oven, remove it and set it aside.
3. Tape the microwave oven door closed so that door does not
swing open while the microwave oven is being handled.
NOTE: To avoid damage to the microwave oven, do not grip
or use the door or door handle while the microwave oven is
being handled.
Rotate Blower Motor
The microwave oven is set for recirculation installation. For wall
or roof venting, changes must be made to the venting system.
NOTE: Skip this section if you are using recirculation installation.
Keep the damper assembly in case the venting method is
changed, or the microwave oven is reinstalled in another
location where wall or roof venting may be used.
Wall Venting Installation Only
1. Remove screws attaching damper plate to top of microwave
oven exterior. Slide damper plate toward the front of the
microwave oven and lift up.
A. Screws
B. Damper plate
2. Keep damper plate and screws together and set aside.
3. Remove 2 screws attaching blower motor to back
of microwave oven.
4. Lift blower motor out of microwave oven.
A. Screws (in recessed holes)
A. Blower motor
5. Rotate blower motor 180° so that exhaust ports face the back
of microwave oven and lower blower motor back into the
microwave oven.
A. Exhaust port
7. Reattach blower motor to back of microwave oven
with 2 screws removed in Step 3.
A
B
A
A
A
6. Using diagonal wire cutting pliers, gently snip out the
rectangular damper vent covers at the perforations.
B
A
A. Diagonal wire cutting pliers
B. Rectangular damper vent cover
Loading ...
Loading ...
Loading ...