Loading ...
Loading ...
Loading ...
10
7. Push microwave oven against mounting plate and hold
in place.
NOTE: If microwave oven does not need to be adjusted, skip
steps 7 through 9.
8. If adjustment is required, rotate microwave oven downward.
Using 2 or more people, lift microwave oven off of mounting
plate and set aside on a covered surface.
9. Loosen mounting plate screws. Adjust mounting plate and
retighten screws.
10. Repeat steps 3 through 6.
11. With the microwave oven centered, and with at least one
person holding
it in place, insert bolts through upper cabinet
into microwave oven. Tighten bolts until there is no gap
between upper cabinet and microwave oven.
NOTES:
Some upper cabinets may require bolts longer or shorter
than 3" (7.6 cm). Longer or shorter bolts are available at most
hardware stores.
Overtightening bolts may warp the top of the microwave
oven. To avoid warping, wood filler blocks (installer to
provide) may be added. The blocks must be the same
thickness as the space between the upper cabinet bottom
and the microwave oven.
A
A. Bolts
For Roof Venting Installation Only
1. Insert damper assembly through the cabinet cutout so
bat gnol eht taht of the damper assembly slid r ednu se
the raised tabs of the damper plate. h tiw e ruces nehT
6
x ³/₈" sheet metal screw.
NOTE: The screw cannot be installed if the damper assembly
is not positioned as shown.
A B C
D E F
A. Raised tabs
B. Damper assembly
C. 6 x ³/₈" Sheet metal screw
D. Upper cabinet cutout
E. Long tab
F. Damper plate
2. Connect vent to damper assembly.
A B
A. Vent
B. Damper assembly (under vent)
Complete Installation
1. Install filters. Refer to the User Instructions
for filter placement.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING
2. Plug microwave oven into grounded 3 prong outlet.
3. Reconnect power.
4. Check the operation of microwave oven by placing 1 cup
(250 mL) of water on the turntable and programming a cook
time of 1 minute at 100% power. Test vent fan and exhaust
by operating the vent fan.
5. If the microwave oven does not operate:
Check that a household fuse has not blown, or that
a circuit breaker has not tripped. Replace the fuse
or reset the circuit breaker. If the problem continues,
call an electrician.
Check that the power supply cord is plugged into
a grounded 3 prong outlet.
See the User Instructions for troubleshooting information.
Installation is now complete.
Save Installation Instructions for future use.
#
#
Loading ...
Loading ...