Loading ...
Loading ...
Loading ...
7 ENGLISH
ASSEMBLY
CAUTION:
Always make sure that your ngers
are not placed on the switch trigger or the con-
tact element and the battery cartridge is removed
before carrying out any work on the pin nailer.
Loading the pin nailer
CAUTION: Always make sure that the battery
cartridge is removed before loading the pin nailer.
Unintentional ring may cause personal injuries and
property damage.
CAUTION: Do not abruptly slide the magazine
of the pin nailer loaded with pin nails. Accidentally
dropping pin nails especially when working in high
places may cause personal injuries.
CAUTION: Load pin nails in the correct direc-
tion. Loading in wrong direction may cause prema-
ture wear and tear of the driver and damage of the
other parts.
CAUTION: Do not use deformed connected
pin nails. Use pin nails specied in this manual.
Using pin nails other than those specied may cause
pin nail jamming and breakage of the pin nailer.
1. Remove the battery cartridge.
2.
Press the locking lever and slide the magazine backward.
3. Align the tip of pin nails with the grooves at the
bottom of the magazine and push the whole part of pin
nails toward the driver guide. (Be careful to place pin
nails in the right direction.)
3
2
4
1
► 1. Pin nails 2. Magazine 3. Locking lever 4. Driver
guide
4. After loading pin nails, push back the magazine in
place until it clicks.
To remove pin nails, follow the installation procedures
in reverse.
Nose adapter
CAUTION: Always make sure that your
ngers are not placed on the switch trigger or
the contact element and the battery cartridge is
removed before installing the nose adapter.
When ring pin nails on the material with easily-marred
surfaces, use the nose adapter. To install the nose
adapter, place it over the driver guide cover so that the
protrusion inside the nose adapter ts to the dent in the
driver guide cover.
You can store the nose adapter on the holder on the
back end of the magazine to keep it from being lost.
4
3
1
2
► 1. Dent 2. Protrusion 3. Nose adapter 4. Holder
Hook
CAUTION: Do not hang the hook from the
waist belt. Dropping the pin nailer, which is caused
by the hook accidentally coming out of place, may
cause unintentional ring and result in personal
injuries.
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
Loading ...
Loading ...
Loading ...