Loading ...
Loading ...
Loading ...
Reinstall the rubber weather seal.
Make sure it is right side up; it is
marked ‘‘TOP.’’
Install the new bulb into the hole,
making sure the tabs are in their
slots. Pivot the hold-down wire
back in place, and clip the end into
the slot.
Push the electrical connector onto
the new bulb. Make sure it is
connected securely. Turn on the
headlights to test the new bulb.
(Driver’s side)
Install the front end of the air
intake duct.
Remove the rubber weather seal
by pulling on the tab.
Remove the electrical connector
from the bulb by pulling the
connector straight back.
Unclip the end of the hold-down
wire from its slot. Pivot the wire
out of the way, then remove the
bulb.
The high beam headlight bulb and
the low beam headlight bulb are
replaced the same way.
Open the hood.
If you need to change the
headlight bulb on the driver’s side,
remove the front end of the air
intake duct by pulling it out.
1.
2.
3.
4.
5.
6.
7.
8.
CONTINUED
On SC model
Lights
Maintenance
203
AIR INTAKE DUCT
０７／０４／２６ １９：０３：１０ ３１ＳＣＶ６５０ ０２０８
2008 Element
Table Of Contents
Main Menu
Loading ...
Loading ...
Loading ...