Loading ...
Loading ...
Loading ...
Installation
Installation
Fine tuning of the doors
If the doors are still not in one level after levelling the
doors by the feet, this mismatch can be remedied by
turning the hinge lifting shaft at the right bottom cor-
ner of refrigerating door with a spanner.
▶ Clockwise turn lifting shaft with spanner to lower
door height.
▶ Antic lock wise turn lifting shaft with spanner to lift
door height.
Waiting time
To the maintenance-free lubrication oil is located in the
capsule of the compressor. This oil can get through
the closed pipe system during slanting transport. Be-
fore connecting the appliance to the power supply you
have to wait at least 2 hours so that the oil runs back
into the capsule.
2 h
3. The stability can be checked by alternately bump-
ing on the diagonals. The slightly swaying should
be the same in both directions. Otherwise the
frame can warp; possible leaking door seals are
the result. A low tendency to the rear facilitates
the closing of the doors.
3.
WARNING!
Do not adjust the hinge lifting shaft excessively to a height which might cause the shaft
to leave its original locked position. (Adjustable height range: 3 mm)
WARNING!
To avoid risks a damaged power cord must be replaced by the customer service (see
warranty card).
Electrical connection
Before each connection check if:
▶ power supply, socket and fusing are appropriate to the rating plate.
▶ the power socket is earthed and no multi-plug or extension.
▶ the power plug and socket are strictly according.
Connect the plug to a properly installed household socket.
28
29
Loading ...
Loading ...