Loading ...
Loading ...
Loading ...
Care and cleaning
Care and cleaning
Cleaning
Clean the appliance when only little or no food is stored.
The appliance should be cleaned every four weeks for good maintenance and to prevent
bad stored food odors.
WARNING!
Do not clean the appliance with hard brushes, wire brushes, detergent powder, petrol,
amyl acetate, acetone and similar organic solutions, acid or alkaline solutions. Please
clean with special refrigerator detergent to avoid damage.
Do not spray or ush the appliance during cleaning.
Do not use water spray or steam to clean the appliance.
Do not clean the cold glass shelves with hot water. Sudden temperature change may
cause the glass to break .
Do not touch the inside surface of the freezer storage compartment, especially with
wet hands, as your hands may freeze onto the surface.
In case of heating check the condition of frozen goods.
WARNING!
Disconnect the appliance from the power supply before cleaning.
Notice
Turn the appliance o only if strictly necessary.
WARNING!
Do not lift the appliance by its handles.
Never place the appliance horizontally on the ground.
WARNING!
Do not replace the LED lamp yourself, it must only be replaced by either the manufac-
turer or the authorised service agent.
22
23
Always keep the door gasket clean.
Clean the inside and housing of the appliance
with a sponge dampened in warm water and
neutral detergent.
Rinse and dry with soft cloth.
Do not clean any of the parts of the appliance in a
dishwasher.
Allow at least 5 minutes before restarting the
appliance as frequent starting may damage the
compressor.
Defrosting
The defrosting of the refrigerator and the freezer compartment are done automatically;
no manual operation is needed.
Non-use for a longer period
If the appliance is not used for an extended period of time, and you will not use the Holiday-
function for the refrigerator:
Take out the food.
Unplug the power cord.
Clean the appliance as described above.
Keep the doors open to prevent the creation of bad odours inside.
Moving the appliance
1. Remove all food and unplug the appliance.
2. Secure shelves and other moveable parts in the fridge and the freezer with adhesive
tape.
3. Do not tilt the refrigerator more than 45° to avoid damaging the refrigerating system.
Replacing the LED-lamps
The lamps adopts LED as its light source, featuring low energy consumption and long ser-
vice life. If there is any abnormality, please contact the customer service . See CUSTOMER
SERVICE.
Parameters of the lamps: 12 V max 5 W.
Loading ...
Loading ...
Loading ...