Loading ...
Loading ...
Loading ...
en Operating the appliance
26
To change the setting:
1. By pressing the button 3, you can
switch the function off ‚:‹‹
or on ‚:‹‚.
2. Press START button `.
The set value is saved.
3. Close the door.
The following applies to TurboSpeed
20 min.:
During the heating up phase the light
spot on the floor is lit constantly. At the
end of the heating up phase the light
spot flashes, indicating that the
appliance can be opened and loaded.
When the appliance has been restarted
and the door closed, the light spot is lit
constantly again during the rinsing
phase.
Remaining running time
display
When the programme is selected, the
remaining running time of the
programme is indicated on the digital
display h.
The running time is determined during
the programme by the water
temperature, the number of utensils as
well as the degree of soiling and may
vary (depending on the selected
programme).
Timer programming
Timer programming *
* depending on model
You can delay the start of the
programme in 1-hour steps up to
24 hours.
1. Open the door.
2. Switch on ON/OFF switch (.
3. Press button P + until the digital
display h jumps to œ:‹‚.
4. Press P + or – button until the
displayed time corresponds with your
requirements.
5. Press START button `, timer
programming is activated.
6. To delete timer programming, press
the P + or – button until h œ:‹‹
is indicated on the digital display.
You can change your programme
selection at any time until the
programme starts.
7. Close the door.
Loading ...
Loading ...
Loading ...