Loading ...
Loading ...
Loading ...
BURNER CONTROLS
To light each burner, push the knob and turn it counter-clockwise to
maximum setting, and hold it for 3 to 5 seconds. The igniter will
spark and ignite the flame. At this position the gas supply is at the
maximum and the flame also at its maximum.
You can reduce the flame size by turning the knob in counter-
clockwise to your desired flame height. Should the burner fail to
light up, turn the knob to its original position and try again.
.
NOTE : When first used, the gas burner will not ignite immediately.
Hold the knob pressed down for an extended time for the gases to
fully fill the operating system.
• Ensure good ventilation of the room. Keep adequate natural
ventilation or install an extractor hood with a discharge tube.
In case of doubt, ask a professional installer for advice.
• Supply the appliance with the type of gas stamped on the
relevant label situated in the immediate vicinity of the gas
connection tube.
• To facilitate ignition, light the burners before placing pans on
the grid. Check that the flame is regular. Always lower the
flame or turn it off before removing the pan.
• Ensure burner caps are installed correctly (See instruction as
below.)
USE GUIDE
13
Loading ...
Loading ...
Loading ...