Loading ...
Loading ...
Loading ...
46 GETTING TO KNOW YOUR VEHICLE
Intermittent Wiper System
Use the intermittent wiper when weather condi-
tions make a single wiping cycle, with a variable
pause between cycles, desirable. Rotate the
end of the lever to the first detent position for
one of four intermittent settings. The delay cycle
can be set anywhere between 1 to 18 seconds.
Front Wiper Control
NOTE:
The wiper delay times depend on vehicle speed.
If the vehicle is moving less than 10 mph
(16 km/h), delay times will be doubled.
Windshield Washers
To use the washer, pull the lever toward you and
hold while spray is desired. If the lever is pulled
while in the delay range, the wiper will start and
continue to operate for two or three wipe cycles
after the lever is released. Then, the intermit-
tent interval previously selected will resume.
If the lever is pulled while in the off position, the
wipers will operate for two or three wipe cycles.
Then, the wipers will turn off.
Mist Feature
Push upward on the wiper lever to activate a
single wipe to clear off road mist or spray from
a passing vehicle. As long as the lever is held
up, the wipers will continue to operate.
NOTE:
The mist feature does not activate the washer
pump; therefore, no washer fluid will be sprayed
on the windshield. The wash function must be
used in order to spray the windshield with
washer fluid.
Mist Control
WARNING!
Sudden loss of visibility through the
windshield could lead to a collision. You might
not see other vehicles or other obstacles. To
avoid sudden icing of the windshield during
freezing weather, warm the windshield with
the defroster before and during windshield
washer use.
20_JL_OM_EN_USC_t.book Page 46
Loading ...
Loading ...
Loading ...