Loading ...
Loading ...
Loading ...
Turn the Program Selector knob to
choose the wash program you
want. The table “Your Program
Guide” shown on page 16 will help
you in selecting the right program.
The Program Selector knob is not a
timer. Once you select a wash
program, the Program Selector
knob will stay at that position for
the whole wash cycle.
3.1
PROGRAM SELECTOR
KNOB
For each wash program your
washing machine automatically
selects a suitable fill water
temperature. If you want to use a
different wash water temperature,
press the Temperature button
repeatedly.
The temperature of warm water will
depend on the temperature and
pressure of your hot and cold water
supplies. The recommended
temperature for warm is 35°C.
You have four
temperatures to
choose from Very
Hot, Hot, Warm
and Cold.
The water temp
lights will tell you
the temperature
for each press of
the button.
3.2
WATER TEMPERATURES
BUTTON
Always check your label for the
washing temperature symbols
which the International Care
Labelling Code now uses
You can adjust the flow rate of the
water supplies to adjust the Warm
temperature. All rinse water
temperatures are cold.
Cold, Warm, Hot.
NOTE:
If you have a cold water connection
ONLY and the hot inlet valve is
capped off (refer installation
instructions) you must select Cold
washes only. To fill detergent, you
must follow steps as below:
1.
Measure the correct amount of
powder detergent by following
the recommendations on the
package.
2.
Mix powder detergent in one
litre of hot or warm water.
3.
Add the pre-mixed detergent to
the wash load.
11
move around
agitator
Loading ...
Loading ...
Loading ...