Loading ...
Loading ...
Loading ...
SIDE BURNER ACCESSORY CARE & USE/INSTALLATION
|
7
BUILTIN INSTALLATIONS
Built-in accessories are intended for installation in a built-in
enclosure constructed of non-combustible materials.
The accessory drops into the opening shown in the cutout detail
drawing and hangs from its counter-top trim. A deck is not
required to support it from the bottom.
Pay special attention to the provisions shown for gas line
hook-up. (See INDEX: “Cut-out Dimensions for Built-in Grills &
Accessories”)
Installation provisions may be made for the power burner
installation. The power burner cooking height may be reduced
to better accommodate large cooking pots. Clearances to
combustible material must be maintained as outlined. No
combustible material shall be used in the construction of a
counter top using a recessed application.
The enclosure should have ventilation holes to prevent gas
build-up in the event of a leak. The counter should be at and
level. (Refer to ANSI Z21.58 Standard for Outdoor Cooking Gas
Appliances, Section 1.7 Enclosures For Self Contained LP-Gas
Supply Systems or local codes for additional information.)
The grill accessory may be powered from either a 120 volt,
60 hertz, 15 amp GFI certi ed outlet installed by a quali ed
electrician OR it may be powered directly from your grill
transformer power supply.
When a grill is not available or if the grill is not located close
enough to the accessory a LASK (Accessory Switch Kit) is
available as an optional purchase.
CLEARANCE TO COMBUSTIBLE MATERIALS
Minimum clearance from the sides and back of the accessory to
adjacent combustible construction below the counter top is 6”
from the sides and back.
Minimum clearance from sides and back of unit to adjacent
combustible construction extending above the counter top is 18”
from the sides and back.
Do not use this appliance under unprotected overhead
combustible surfaces.
B
EF
O
RE Y
OU
S
TAR
T
...
co
n
t
in
u
e
d
Loading ...
Loading ...
Loading ...