Loading ...
Loading ...
Loading ...
16 49-1000458 Rev. 1
Master Light
Switch
All-Refrigerator
Master
Light
Switch
All-Freezer
CARE AND CLEANING
PREPARING FOR VACATION
Set the icemaker power switch to the OFF position and
be sure to shut off the water supply to the refrigerator.
For long vacations or absences, remove food from the
refrigerator/freezer. Set the control to OFF, and clean the
interior with a baking soda solution of one tablespoon (15
ml) of baking soda to one quart (1 liter) of water. Leave the
door open.
For shorter vacations, remove perishable foods and
leave controls at regular settings. However, if the room
temperature is expected to drop below 60°F (16°C), follow
the same instructions as for long vacations.
USING THE MASTER LIGHT SWITCH
This feature turns off the lights inside the unit. The switch
is located behind the top access panel. Lift up the panel to
access the switch. Turning off the master switch does not
turn off all power to the unit.
LIGHT BULB REPLACEMENT
For upper and lower light bulb replacement, visit us at
monogram.com. In Canada, visit monogram.ca.
REFRIGERATOR/FREEZER LOCATION
Ŷ Do not install the refrigerator/freezer where the tem-
perature will go below 55°F (13°C). It will not run often
enough to maintain proper temperatures.
Ŷ Do not install the refrigerator/freezer where temperatures
will go above 100°F (37°C). It will not perform properly.
Ŷ Do not install the refrigerator/freezer in a location
exposed to water (rain, etc.) or direct sunlight.
Ŷ Install it on a floor strong enough to support it fully
loaded.
For proper installation, the refrigerator/freezer must
be placed on a level surface of hard material the same
height as the rest of the flooring. This surface should
be strong enough to support a fully loaded refrigerator/
freezer, or approximately 1,200 lbs. each. See the
Installation Instructions for complete directions.
Loading ...
Loading ...
Loading ...