Loading ...
Loading ...
Loading ...
49-1000458 Rev. 1 11
ACCESSING THE ICEMAKER AND ICE
STORAGE BIN (freezer models)
The icemaker is located behind the first drawer on the right
of the freezer. The ice bin is the second drawer.
To remove the ice bin:
Open the access door to reach the icemaker. Set the
icemaker power switch to the OFF position. With the
access door closed, support the storage bin at the bottom
while slightly lifting. Pull bin straight out. See Drawer
Removal section.
To replace the ice bin:
Slide the bin back until the tab on the bin locks into the slot
on the shelf. After replacing the ice bin, open the access
door to reach the icemaker. Set the icemaker power switch
to the ON position.
AUTOMATIC ICEMAKER
WARNING
Connect to potable water supply only.
A cold water supply is required for automatic icemaker
operation. The water pressure must be between 40 and
120 psi (275-827 kilopascals).
AVERTISSEMENT
Raccordez l’appareil à une
alimentation d’eau potable seulement. Une alimentation
d’eau froide est requise pour faire fonctionner
la machine à glaçons et le pichet à remplissage
automatique. La pression d’eau doit se situer entre 40
et 120 psi. (275 à 827 kPa).
ADVERTENCIA
Realice la conexión a un
suministro de agua potable únicamente. Se requiere
un suministro de agua fría para el funcionamiento de
la máquina de hielos automática. La presión del agua
deberá estar entre 40 y 120 psi (275-827 kilopascales).
CAUTION
To minimize the risk of personal injury,
avoid contact with the moving parts of the ejector
mechanism, or with the heating element that releases
the cubes. Do not place fingers or hands on the
automatic ice making mechanism while the refrigerator
is plugged in.
ATTENTION
Pour minimiser les risques de
blessures, évitez le contact avec les pièces mobiles du
mécanisme éjecteur, ou avec l’élément chauffant qui
libère les glaçons. Ne posez pas les doigts ou les mains
sur le mécanisme de la machine à glaçons automatique
pendant que le réfrigérateur est branché.
PRECAUCIÓN
Para minimizar el riesgo de
lesiones personales, evite el contacto con las partes
móviles del mecanismo eyector o con el elemento de
calefacción que libera los cubos. No coloque los dedos
ni las manos en el mecanismo de la máquina de hielo
automática mientras el refrigerador esté enchufado.
A newly-installed refrigerator may take 12–24 hours to
begin making ice.
The icemaker will produce seven cubes per cycle—
approximately 15 cycles in a 24-hour period, depending
on freezer compartment temperature, room temperature,
number of door openings and other use conditions.
If the freezer is operated before the water connection is
made to the icemaker, set the power switch to OFF.
When the freezer has been connected to the water supply,
set the power switch to ON.
Throw away the first full bucket of ice to allow the water
line to clear.
Be sure nothing interferes with the sweep of the feeler
arm.
When the bin fills to the level of the feeler arm, the
icemaker will stop producing ice.
It is normal for several cubes to be joined together.
If ice is not used frequently, old ice cubes will become
cloudy, taste stale and shrink.
NOTE: Icemaker works best between 40 and 120 PSI
(275-827 kPa) home water pressure.
Feeler Arm
Icemaker
Power
Switch
Icemaker
Ice bin
ON/OFF switch
Loading ...
Loading ...
Loading ...