Loading ...
Loading ...
Loading ...
5
• Only push and hold the self-clean
button when you want to activate
the self-cleaning function. Do not push
and hold whilst ironing. Boiling water
and steam will drip from the holes
on the soleplate during the cleaning
process. Due caution and attention
should be exercised.
• Do not allow the cord to touch
hot surfaces.
• Do not leave the iron unattended
when in use.
• If the iron is not used for an extended
period, disconnect the iron from the
power outlet.
• If the iron is set to a low temperature
on the temperature control (i.e.
synthetic or silk) and also on any of
the steam control settings, there may
be leakage from the soleplate. This is
due to the iron temperature not being
high enough to vaporise the water
and create steam. Therefore, ensure
that the steam control is always set
to correspond with the setting on the
temperature control as seen in Table
A in section ‘Setting the Temperature’
on page 8.
• The iron must be used and rested on a
stable surface.
• When placing the iron on its heel,
ensure that the surface on which the
heel is placed is stable.
• The iron is not to be used if it has been
dropped, if there are visible signs of
damage or if it is leaking.
• Always switch off at the power outlet
then unplug the iron from the outlet:
– Before filling with water or
emptying it.
– Before leaving it unattended.
– Before cleaning and maintenance,
unless otherwise specified in this
booklet.
– Immediately after use.
• The iron incorporates a thermal
safety fuse to protect the iron from
overheating. However the iron
should not be left unattended while
it is connected to the power outlet.
Special care should always be taken
when there are children in the home/
vicinity of the iron.
• Always turn the Variable Temperature
Control to MIN, then switch off at the
power outlet and then unplug the iron
when not in use.
• Allow the iron to cool completely
before storing in an upright position
on its heel.
• Store the iron out of reach of children.
• Do not allow the iron to lay flat on the
soleplate when stored as water may
seep through the steam holes if the
tank is not empty.
• Always store the iron in the upright
position on its heel. Do not leave
the iron unattended while in use,
connected or on an ironing board.
• Do not store the iron with water in the
water tank. Always empty the tank
after use.
• Ensure the iron is cool before storing or
wrapping the cord around the storage
heel facility.
• To prevent damage to the iron, do
not use alkaline cleaning agents
when cleaning; uses a soft cloth
and mild detergent.
• Regularly inspect the cord, plug
and actual iron for any damage. If
damage is found in any way, or the
iron has been dropped, immediately
cease use of the iron and return the
entire iron to your nearest authorized
Kambrook Service Centre for
examination, replacement or repair.
• Keep the iron clean. Follow the
cleaning instructions provided in
this book.
Loading ...
Loading ...
Loading ...