Loading ...
Loading ...
Loading ...
13
Replacing the oven light (some models)
The interior oven light bulb is located at the upper left rear
of the oven cavity.
To replace the oven light bulb
To raise the cooktop for cleaning (some models)
1. Grasp the sides and lift from the front (See Fig. 1).
Lift-up rods will support the top in a raised position.
Only lift the cook top far enough to allow the support
rods to snap into place.
2. Clean underneath using a clean cloth and hot, soapy
water.
3. To lower, hold the cooktop up and gently push back
on each rod to release the notched support. Hold the
cooktop while slowly sliding the lift rods down into the
range frame.
Fig. 1
CARE&CLEANING
For models that have a visible lower bake element
ONLY- This bake element was designed to be tilted up
using your hand from the front of the bake element for
cleaning purposes. Remove the bottom oven rack before
raising the element. Do not to raise the element more
than 4 or 5 inches from the resting position.
Cleaning under lower element (some
models)
Cleaning under cooktop (some models)
1. Turn electrical power off at
the main source or unplug
the range.
2. Replace bulb with a new 40
watt appliance bulb.
3. Turn power back on again
at the main source or plug
the appliance back in.
4. The clock will need to be
reset (some models). To
reset, see “Setting the
clock” in this Use & Care
Guide.
oven
light
cooktop
support rods
CAUTION
The oven bake and broil elements may appear to have
cooled after they have been turned OFF. The elements
may still be hot and burns may occur if these elements
are touched before they have cooled sufciently.
CAUTION
Be sure the range is unplugged and all parts are COOL
before replacing oven light. Wear a leather-faced glove for
protection against possible broken glass.
CAUTION
When lowering the lift-up range cooktop, grasp the
sides with nger-tips only. Be careful not to pinch
ngers. DO NOT drop or bend the range cooktop
when raising or lowering. This could damage the
cooktop surface.
Loading ...
Loading ...
Loading ...