Loading ...
Loading ...
Loading ...
802254 - HT BC, BCHA, AIO, User Guide - June 2015 - V2.00 Page 13 of 24
After replacing the filter, the counters should be reset
On start up, the Zip HydroTap starts a self-calibration program. The controls
take the system through the calibration process. Once complete, the system
reverts back to normal operation. If you would like to calibrate the system
anytime after initial installation, please follow the steps below.
1. Press [MENU] button for main
menu.
2. Press [Install] button.
3. Press [Boiling Calibration] button.
4. In the next screen, press [Calibrate]
to start calibration.
Boiling Calibration Screen
3 - Boiling Calibration
This function should only be considered when a Booster unit is installed.
G4 HydroTap Booster Screen
4 - Booster
Note:
Failing to make the correct selection for ‘Booster’ will effect product
performance.
2 - Filter Reset
LCD Screen operation - Section C
NOTE: Occasionaly the system will vent steam from the tap. This is normal
operation as HydroTaps are programmed to re-calibrate at regular intervals.
1.
Press the [MENU] button for main
menu.
2.
Press the [Install] button.
3.
Press the [Filter Reset] button.
4.
To set the filter life or edit filter
usage, refer to section G- Filter.
1.
Press the [MENU] button for main
menu.
2.
Press the [Install] button.
3.
Press the [Booster] button.
4.
If a Booster is installed, select YES
to enable the Booster.
5.
Dispense boiling water for a
minimum of 30 secs and check
the outlet hose from the Booster is
warm.
6.
Otherwise select NO, if no Booster
is installed
Loading ...
Loading ...
Loading ...