Loading ...
Loading ...
Loading ...
505
Troubleshooting Guide
The charger cannot charge batteries other than the provided LP-E19
and LP-E4N/LP-E4. The three charge lamps and <CAL> lamp will
blink in green.
While charging a battery, if the three charge lamps blink in green
consecutively or if they blink consecutively in green with the <CAL>
lamp blinking in green, remove the battery from the charger. Contact
your dealer or nearest Canon Service Center.
While calibrating a battery, if the three charge lamps blink, remove the
battery from the charger. Contact your dealer or nearest Canon
Service Center.
Make sure the battery is installed properly in the camera (p.47).
Make sure the card slot cover is closed (p.49).
Recharge the battery (p.42).
If the power is turned off while an image is being recorded to the card, the
access lamp will remain on or continue to blink for a few seconds. When
the image recording is completed, the power will turn off automatically.
Do not use any battery other than the genuine Battery Pack LP-E19 or
LP-E4N/LP-E4.
Remove and install the battery again (p.47).
If the electrical contacts are dirty, use a soft cloth to clean them.
All three charge lamps of the charger blink.
The camera does not operate even when
the power switch is set to <1>.
The access lamp still lights or blinks even when
the power switch is <2>.
[Does this battery/do these batteries display the Canon logo?]
is displayed.
Loading ...
Loading ...
Loading ...