Loading ...
Loading ...
Loading ...
Page:
5
User Manual:
Your Esatto Bar Fridge
Installation Instructions
BEFORE USING YOUR BAR FRIDGE
→ Remove the exterior and interior packing.
→ Keep away from heat and avoid direct sunlight.
→ Do not place the fridge in moist or watery places to prevent rust or reduction
of insulating eect.
→ Before connecting the bar fridge to the power source, let it stand upright for
approximately 1 hour. This will reduce the possibility of a malfunction in the cooling
system from handling during transportation.
→ Clean the interior surface with lukewarm water using a soft cloth.
INSTALLATION LOCATION:
→ When selecting a position for your bar fridge you should make sure that the oor is level,
and that the room is well ventilated with an average room temperature of between 16°
and 35°.
→ Always avoid locating your bar fridge near a heat source, such as a heater.
→ Also avoid direct sunlight as it may increase the electrical consumption.
→ Extreme cold ambient temperatures may also cause the unit not to perform properly. This
unit is not designed for use in a garage or outdoor installation.
→ Do not drape the unit with any covering.
→ When installing the unit, ensure that 10cm of free space is left at both sides, 10cm at the
rear and 30cm at the top of the unit. This will allow cold air to circulate around the wine
cooler and improve the eciency of the cooling process.
→ The door can be hinged to open to the right or to the left, depending on what better suits
the location.
→ Please ensure there is adequate space for the door to fully open.
→ Adjust the two levelling feet to ensure that the bar fridge is horizontally and vertically level.
1 Small door
2 Drain tray
3 Steel wire shelf
4 Adjustable foot
5 Thermostat
6 Wire steel bar
Loading ...
Loading ...
Loading ...