Loading ...
Loading ...
Loading ...
22
Remote control
Installing the batteries
Insert the batteries into the remote control before using it. If the remote control
starts to malfunction, replace the batteries. If not use the remote control for long
period, remove the batteries from the remote control and store them in a safe
place.
1.
Holding the hook part of the battery cover, remove it.
2.
Align and insert the two AA batteries according to
their plus and minus terminals as indicated in the
remote control.(Use the appropriate AA carbon-
zinc or alkaline batteries (non-rechargeable)
according to laws and regulations. )
3.
Replace the battery cover in the direction of the arrow
and snap it back into place.
►Always handle the batteries with care and use them only as
directed. Improper use may result in battery explosion, cracking or leakage, which
could result in re, injury and/or pollution of the surrounding environment.
• Be sure to use only the batteries specied. Do not use batteries of different types at
the same time. Do not mix a new battery with used one.
• Make sure the plus and minus terminals are correctly aligned when loading a battery.
• Keep a battery away from children and pets.
• Do not recharge, short circuit, solder or disassemble a battery.
• Do not place a battery in a re or water. Keep batteries in a dark, cool and dry place.
• If you observe battery leakage, wipe out the leakage and then replace a battery.
If the leakage adheres to your body or clothes, rinse well with water immediately.
• Obey the local laws on disposing the battery.
WARNING
Remote control
Using the REMOTE ID function
Use this function to control specic projectors by the remote
control assigned the same ID number when you use multiple
projectors of the same type at the same time.
Assign an ID number to each projector before using the
REMOTE ID item in the SERVICE menu of the OPTION
menu (90). Press the ID button with the same ID number
as assigned to the projector you are going to control. The ID
button selected will light for several seconds.
• Each time you press any button (except ID buttons), the ID button of
current selected ID number will light.
• To conrm the projector's current ID, press any ID button for three seconds.
Its number will be shown on each screen regardless of set ID of projector.
NOTE
2
1
3
ID
buttons
Loading ...
Loading ...
Loading ...