Loading ...
Loading ...
Loading ...
20
3. Close the door slowly and pull out the panel upwards by the
door handle. (Fig. B)
4. Hold the intermediate panel firmly and unscrew the retaining
clips on the door. Slide the panel upwards and out. (Fig. C).
5. Do NOT unscrew the left and right-hand screws from the
sheet metal part (Fig. D).
Note: Clean the glass panels with glass cleaner and a soft
cloth.
: Risk of injury!
Scratched glass in the appliance door may develop into a
crack. Do not use a glass scraper, sharp or abrasive cleaning
aids or detergents.
Refitting
1. Grip the upper section of the intermediate panel with both
hands and insert it into the guide at the bottom. (Fig. A).
Caution!
Make sure that the panel is aligned evenly at the bottom.
2. The lettering must be positioned in the top right corner, so
that it can be easily read. (Fig. B).
3. Tighten the retaining clips on the right and left of the panel
using a TORX screwdriver (TORX 20). (Fig. C)
4. Insert the door panel into the guide with both hands. (Fig. D).
5. Push the door panel downwards, lift it slightly and hook it in
at the top (Fig. E).
Caution!
Make sure that the door panel is sitting flush with the control
panel.
6. Fully open the door, while holding the panels firmly with one
hand (Fig. F).
7. Push the door downwards again and tighten the screws
hand-tight using a TORX screwdriver (TORX 20) and close
the door. (Fig. G).
Caution!
The oven may only be used again when the panels are
correctly installed.
$
%
&
'
$
%
&
'
(
)
*
Loading ...
Loading ...
Loading ...