Loading ...
Loading ...
Loading ...
12
Chapter 11: PROGRAMMING THE TIMER
To program the timer, follow these steps:
• Press the “TIMER” button and the timer will start ashing.
• Press the “UP” or “DOWN” button to adjust the time.
• Press the ”TIMER” button to save the changes or wait 10 seconds until the timer stops
ashing.
Chapter 12: USING THE DEVICE
1. Connect the electrodes to the TENS control unit.
2. Place electrodes on your skin.
3. Turn the Device ON by pressing the “ON/OFF” button.
4. Using the intensity control buttons, change the intensity for each channel (Note: intensity will
increase at a lower rate for the rst 10 intensity levels and increase at a faster rate from level 11
to 30).
5. The device will turn off automatically if the timer was set (count down minutes are shown on the
display). If it was set to C (continuous) the device has to be turned OFF manually.
6. To turn the device OFF manually, press the “ON/OFF” button for 3 seconds.
Chapter 13: ENDING YOUR TREATMENT SESSION
After the device shuts off, use the following steps as a quick reference for ending your session:
• Disconnect the lead wire(s) from the control unit.
• Remove electrodes from skin and place them back on the transparent liner. When removing
electrodes, always pull in the direction of hair growth. DO NOT REMOVE ELECTRODES
WHILE THEY ARE CONNECTED TO THE UNIT TO AVOID ANY ELECTRIC DISCHARGE.
Do NOT pull on the wires, but peel off on the corner of the electrode.
• Disconnect the lead wire(s) from the electrodes.
• Store the components in the storage bag.
Loading ...
Loading ...
Loading ...