Loading ...
Loading ...
Loading ...
Operating Instructions
Safety Instructions
Installation
Instructions
Troubleshooting Tips
Consumer Support
48
Before you call for service…
Problem Possible Causes What To Do
Excessive smoking Excessive soil. • Touch the Clear/Off pad.
Oven door will not open Oven too hot. • Allow the oven to cool below locking temperature.
after a clean cycle
Oven not clean after Oven controls not properly set. • See the Using the self-cleaning oven section.
a clean cycle
Oven was heavily soiled. • Clean up heavy spillovers before starting the clean cycle.
Heavily soiled ovens may need to self-clean again or for
a longer period of time.
Oven door will not Oven is too hot. • Allow the oven to cool below locking temperature.
unlock (on models Do not lock the door with the door latch except when
with a door latch) using the self-clean feature.
Self clean light blinks A power interruption occurred. • Touch the Clear/Off pad, wait for the oven to cool, and
during self clean cycle on models with a latch, move it to the left as far as
it will go. Reset the range controls to the desired
settings. See the Using the self-cleaning oven section.
Self-cleaning cycle has been • Close the oven door. On models with a latch, move it all
selected, but the oven door was the way to the right.
not closed, and on models with a
latch, it was not moved all the
way to the right.
On models with a latch, it • Move the latch handle to the right only when setting
was moved to the right, but a the self-cleaning cycle.
program other than self-cleaning
was selected.
“F—and a number or On models with a door latch, • The latch may have been moved, even if only slightly,
letter” flash in the if a function error code appears from the locked position. Make sure the latch is moved
display
(on some models) during the self-cleaning cycle, to the right as far as it will go.
check the oven door latch.
You have a function error code. • Touch the Clear/Off pad. Allow the oven to cool for
one hour. Put the oven back into operation.
If the function code repeats. • Disconnect all power to the range for 5 minutes
and then reconnect power. If the function error
code repeats, call for service.
Troubleshooting Tips
Loading ...
Loading ...
Loading ...