Loading ...
Loading ...
Loading ...
10
5. Align the 2 screw holes at the rear of the pump. Use two
#8-32 x 3/8" screws, supplied. See “Parts Locations”
illustration.
6. Install vent tube (5/16" I.D. x 32" [81 cm]) to drain pump
reservoir vent behind the wiring cover. Use supplied 5/8" small
adjustable clamps. See “Parts Locations” illustration. Use
plastic retainer to keep vent hose secure to top of inner deck.
NOTE: Do not install household drain tube this time.
Parts Locations
7. Remove wiring cover. Refer following illustration for location of
the screws.
8. Route vent tube through plastic retainer that is located
underneath top deck in open pump area as shown in
illustration. Using cable tie, tie the vent tube to the black
suction tube which is located behind the wiring cover. Refer
"Vent Tube" illustration.
Vent Tube
NOTE: Do not pinch, kink or damage the vent tube. Check that it
is not damaged or pinched or kinked between the cabinet and the
ice maker.
9. Secure wiring cover back in place.
10. Remove power cord clamp and ground screw attached to ice
maker power cord, which is mounted to the unit base. See
“Parts Locations” illustration.
NOTE: Clamp and screw will be reused.
11. Coil ice maker power cord into a 4" (10.2 cm) diameter
coil. Wrap electrical tape around the power cord in several
places to keep the cord in a coil. Locate coiled power cord
between the drain pump and side of enclosure and plug into
the receptacle of the drain pump. See “Parts Locations”
illustration.
12. Attach the drain pump power cord to ice maker unit base with
clamp and screw (removed in Step 6) that was used to attach
ice maker power cord. See “Parts Locations” illustration.
13. Install new drain tube (5/8" I.D. x 5¹⁄
8
") from ice maker bin to
drain pump reservoir inlet using new adjustable clamps. See
“Drain Tube” illustration.
NOTES:
■ Do not kink.
■ Trim tube length if required.
Drain Tube
C
H
I
G
F
E
D
B
A
A. Vent tube
B. 5/8" hose clamp
C. Drain pump discharge tube
D. Drain pump
E. Ice maker unit power cord
F. #8-32 x 3/8" pump mounting
screws
G. Drain pump power cord,
clamp and screw
H. Plastic retainer
I. Wiring cover
A
B
A. Wiring cover
B. Screws
A. Vent tube
B. Cable ties
C. Plastic retainer
A
B
C
A
B
C
D
A. 7/8" adjustable hose clamp
B. Drain tube (ice bin to drain pump)
C. 7/8" adjustable hose clamp
D. Drain pump reservoir inlet
Loading ...
Loading ...
Loading ...