Loading ...
Loading ...
iMPORTANT SAFETY
iNSTRUCTiONS
installation of this cooktop must conform with local
codes or, in the absence of local codes, with the
National Fuel Gas Code ANSi Z223.1--1atest edition in
the United States, or in Canada, with the Canadian Fuel
Gas Code, CAN/CGA B149 and CAN/CGA B149.2.
This cooktop has been design certified by American
Gas Association (A.G.A.). As with any appliance using
gas and generating heat, there are certain safety
precautions you should follow. You will find them in the
Use and Care Guide, read it carefully.
• Air curtain or other overhead hoods, which operate
by blowing a downward air flow on to a range, shall
not be used in conjunction with gas ranges other
than when the hood and range have been designed,
tested and listen by an independent test laboratory
for use in combination with each other.
• Be sure your cooktop is installed and grounded
properly by a qualified installer or service
technician.
• This cooktop must be electrically grounded in
accordance with local codes or, in their absence,
with the National Electrical Code ANSI/NFPA
No. 70--latest edition in the United States, or in
Canada, with the Canadian Electrical Code, CSA
C22.1 Part 1.
• The burners can be lit manually during an
electrical power outage. To light a burner, hold a
lit match to the burner head, then slowly turn the
Surface Control knob to LITE. Use caution when
lighting burners manually.
• Do not store items of interest to children in the
cabinets above the cooktop. Children could be
seriously burned climbing on the cooktop to reach
items.
• To eliminate the need to reach over the surface
burners, cabinet storage space above the burners
should be avoided.
• Adjust surface burner flame size so it does not
extend beyond the edge of the cooking utensil.
Excessive flame is hazardous.
• Never use your cooktop for warming or heating
the room. Prolonged use of the cooktop without
adequate ventilation can be hazardous.
• Do not store or use gasoline or other flammable
vapors and liquids near this or any other
appliance. Explosions or fires could result.
[:_ The electrical power to the cooktop
must be shut off while line connections are being
made. Failure to do so could result in serious
injury or death.
1. Wall Outlet (305om
Location !c ;I
NOTE: if an outlet (20
10"
is not available, (25.4ore)
have one installed
i *
by a qualified e_technician. Recomm
area for 120V
grounded outlet
on rear wall 22"
(55.9 ore)
CL of unit
I
i /
/
"CL of unit
Figure 3
2. Installation
insert the cooktop into the countertop opening.
Note: After inserting the cooktop into the
countertop opening, make sure the unit is sitting
on the metal flange around the top of the burner
box. Cooktop must not sit on the porcelain top.
Avoid cutting an oversized hole in the countertop.
3. Clamp Down Information
Once the cooktop is installed in the counter opening,
you must clamp the unit down as shown.
Seal
Cooktop _ /
_ / Countertop
A _g_ket"_ _ _r
.L__-. Thumb Screw
Figure 4 _>
To clamp down, insert the bracket with the offset side
of the angle into the slots on each side of the unit. The
thumb screw should then be run through the bracket,
up against the bottom of the counter. Tighten until the
unit draws down.
3
Loading ...
Loading ...
Loading ...