Loading ...
Loading ...
Loading ...
06
TFLW75
2.6 Transport
— Always move the appliance cautiously. Do not use the machine door or the handle of the
detergent dispenser, to lift the appliance.
— Transportation bolts should be reinstalled within the machine by a specialised person,
prior to transporting the appliance.
— Ensure that all accumulated water is drained from the appliance before moving.
2.7 Installation Positioning
— Ensure that your appliance is installed on solid and flat ground, in a level position.
— Please do not place the appliance on a slope, soft carpet or wooden floor.
— Your appliance should only be installed within an internal environment. Do not install
the appliance outdoors.
Removing the Transportation Bolts
Before using this washing machine, transport bolts must be removed from the backside of
this machine. Please take the following steps to remove the bolts:
— Loosen all bolts with a spanner and then remove them.
— Use the plugs (supplied) to plug the holes.
— Keep the transport bolts for future use.
Level Adjusting
— If the floor is obviously uneven, your appliance feet need to be adjusted. If your
appliance isn’t level, it will cause your appliance to vibrate, and potentially move from its
position.
— Once you’ve positioned your washing machine, press down from the top in all four
corners to ensure that it’s completely stable (i.e. not rocking in any direction). Also use a
spirit level to ensure that it is completely level in all directions.
— Should you need to make adjustments, use a spanner to turn the appliance legs until
it makes contact with the floor. Turn the leg using one hand and then fasten the nut up
against the appliance cabinet, to lock the leg in place.
— After making any adjustments to the appliance legs,
re-check to ensure it is level and no rocking occurring.
Connect the Inlet Pipe
— Connect the hose elbow to the cold water outlet, screwing in a clockwise direction.
— Connect the other end of the inlet hose to the water inlet valve on the rear of the
washing machine.
— After installation, if there are any leaks detected, remove the hose and re-install using
the steps above. The hose is designed to be used on a standard washing machine
cock outlet.
Position the Outlet Hose
— The outlet hose (used to drain the discharged water) is to be ideally connected to the
relevant waste pipe, although it can also be positioned to drain into a sink/trough. Note
that the outlet hose has a minimum outlet position of 60cm and a maximum position of
100cm (as illustrated below).
Note:
If you are positioning the outlet hose to drain into a sink or trough, please ensure that it is
fixed in place and that the sink remains unblocked at all times.
Loading ...
Loading ...
Loading ...